CONNECTS2 CAM-32 Van/Camper Van Reverse Camera with 1099 HD CCD Sensor User Manual
PRODUCT FEATURES:
Image Sensor: 1099 HD CCDResolution: 560 TV LinesMinimum Illumination: 0.1 LumensHorizontal Angle: 135 DegreesVertical Angle: 125 DegreesTV System: NTSCVideo Output: 1.0V p-p 75ohmOperating Voltage: 12-24V DC (Negative Ground)Current Consumption: 45-178 mA @ 13.8VElectronic Shutter: NTSC 1/60S, PAL 1/50SOperating Temperature: -20 Degrees C to +75 Degrees CWaterproof Rating: IP68Parking Lines: YesRemovable Lines: YesImage Adjustment: Yes (Mirror/Normal)Infra-Red LED’s: Yes
DISCLAIMER:
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.The place of installation must be free of moisture and away from heat sources. Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any technical issues. With this in mind, when contacting Connects2, try to provide as much Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
CONTENTS
– Camera with mounting plate and 30cm connection cable– Instructions
INSTALLATION
Note: CAM-RCA1 extension cable is required for installation.
- Connect the Black wire to a suitable ground and the Red wire to a switched +12V supply.
- If the camera is to be used in the rear of the vehicle, the Red wire should be connected to the reversing light circuit or an interface which provides a reverse signal.
- Select a suitable location for the camera and ensure that the area is free from all cables, fuel & oil. Whenever possible, avoid locations that are subject to road dirt & water spray.
- Remove the five screws and nuts from the camera housing and remove themounting plate.
- Attach the mounting plate to the vehicle, refit the camera housing to the mounting plate and connect the CAM-RCA1 extension cable to the 30cm connection cable.(NB: To stop the nuts falling out of the mounting plate during installation, apply a small amount of Blu-tack or a similar product to the hole containing each nut).
- Connect the camera to the display screen via the Yellow RCA connector and ensure that the image is displayed correctly.
- Adjustment of the camera may be required to ensure that the correct angle/orientation of the image is achieved.
- To swap the image from mirror to normal view, disconnect the shorting link from the small White looped wire located on the 30cm connection cable.
- To remove the parking line feature, disconnect the shorting link from the small Blue looped wire located on the 30cm connection cable.
Subscribe to our YouTube Channel for installation guides and tips… www.youtube.com/connects2
[xyz-ips snippet=”download-snippet”]