Connects2 CAM-MB5.2 Mercedes Brake Light Reverse Camera User Manual


User ManualCAM-MB5.2Mercedes Brake Light Reverse CameraMercedes Benz Sprinter (W906) 2006 – 2016


Image Sensor: 1/3” CMOSResolution: 510 x 492 (NTSC), 500 x 582 (PAL)TV Lines: 700Signal System: NTSC/PALMinimum Illumination: 0 Lux (LED’s on)Infra-Red LED’s: YesBuilt-in lens: f-2.8mmWaterproof Rating: IP69KViewing Angle: 120° (Diagonal) x 95° (Horizontal) x 75° (Vertical)Electronic Shutter: 1/60 (NTSC) 1/50 (PAL) – 1/100,00 secondOperating Voltage: 12V DC (Negative Ground)Current Consumption: 90-138mA @ 13.8VOperating Temperature: -30 Degrees C to +70 Degrees CCertification: FCC, CE, E-mark, ISO9001,TS16949, RoHs


Prior to InstallationRead the manual prior to installation. Technical knowledge is necessary for installation.Please ensure you use the correct tools to avoid damage to the vehicle or product.Connects2 can not be held responsible for the installation of this product.Technical SupportConnects2 wants to provide a fast and suitable resolution should you encounter any technical issues. With this in mind, when contacting Connects2, try to provide as much information as possible. This will speed up the process and help us to help you.Please use our dedicated online technical support center:


  • Brake light camera with 35cm cable to Male 4pin camera connector.
  • 10m Male to Female 4pin extension cable
  • Instructions


  • Remove the factory-installed third brake light from the vehicle and unplug the connection cable.
  • Connect the new combined brake light/camera assembly to the brake light connector and test to ensure correct brake light operation, taking care not to trap any cables.
  • Connect the Black wire to a suitable ground and connect the Red wire to the reversing light circuit or an interface that provides a reverse signal.
  • Connect the camera to the 4pin extension cable, connect the extension cable to the camera connection cable and connect the camera connection cable to the display screen via the Yellow RCA connector and ensure that the image is displayed correctly.


To select PAL – leave the green wires separated

To Select NTSC – Connect the Green wires together

Subscribe to our YouTube Channel for installationguides and tips…

[xyz-ips snippet=”download-snippet”]