Dalmo AKF3F Hands-Free Convenience in the Kitchen User Guide
Dual Sensor Model
Touchless Kitchen Faucet
There is a sensor at the bottom of the DaImo faucet, Just wave in front and rinse! The second sensor – The spray nozzle works to turn the water on automatically when stretched, and off when putting back..
When in automatic mode (the sensor box and the handle switch are turned on) The first sensor: there is a sensor at the bottom of the Dalmo faucet, Just wave in front and rinse! No more making breakfast and having egg on your hands and having to turn on the faucet; The second sensor: the spray nozzle works to turn the water on automatically when stretched, and off when putting back.
Dual Sensor Mode & Manual Mode
Please oat attention to the position of the knob to identify the mode of the faucet.
Turn knob counter-clockwise completely to use the faucet in manual mode.
Turn knob clockwise completely to use the faucet in sensor mode.
Adjusting Hands-Free Temperature
When you use your faucet in the hands-free mode, simply use the handle to adjust to your desired temperature mix.
Dual Sensor Mode
The First Senor
Turn on the faucet and wave your hand over the Sensor, Set water temperature to desired setting. The water temperature changes by manipulating the handle. Run the water and it will stop automatically in 3 minutes. Check for leaks.
The Second Senor
The second sensor – Turn on the faucet , then pull out the spray head (the Infrared sensor will start working when the spray head Is pulled out).Sllde the spray head back in original position, and the water turns off.
Battery installation
Remove the battery pack cover on control box and take out the battery pack; insert 4 AA balleries (sold separately). Put the battery pack back in the control box and replace the cover firmly. The batteries should be charged or changed when the senso flashes a red light.
Maunal Mode
Manual Mode operation
Turn knob counter-clockwise completely to use the faucet in manual mode.
Sensor Mode operation
Turn knob clockwise completely to use the faucet in sensor mode.
Troubleshooting
- Q: The first sensor (wave sensor). doesn’t work.A: Step 1: Check whether all 4 5A batteries are installed in place and whether the positive and negative poles of the batteries are properly connected.Step 2: Ensure the handle is in opening status, the knob in clockwise status, and the sensor is flashing.Step 3: Check if the control box is connected with the connecting line properly.
[xyz-ips snippet=”download-snippet”]