Danby Ice Maker DIM2500WDB Owner’s Manual

    Owner’s Use and Care Guide

ICE MAKER MACHINE 

Danby Products Limited, Ontario, Canada N1H 6Z9Danby Products Inc., Findlay, Ohio, USA 45840

TO OBTAIN WARRANTY SERVICE YOU MUST PROVIDE A VALID PROOF OF PURCHASE. PLEASE STAPLE YOUR RECEIPT TO THIS PAGE FOR  FUTURE REFERENCE.

IMPORTANTThis machine is intended to produce ice only. It is not intended for the long-term storage of ice. Move any excess ice into a freezer for long-term storage (>6 hours) if you desire to keep it. Ice that is left to sit in the bucket will melt over time.

 

Model  DIM2500WDB

WELCOMEWelcome to the Danby family. We’re proud of our quality products, and we believe in dependable service like you will f nd in this owner’s use and care guide, and like you will receive from our friendly customer service department. Best of all, you will experience these values each and every time you use your Danby appliance. That’s important because your new appliance will be a part of your family for a long time.

Note the information below; you will need this information to obtain service under warranty.

Model No: ____________Serial No:____________Date Purchased:____________

NEED HELP?Before you call for service, there are a few things you can do to help us serve you better:Read this Owner’s Use and Care Guide: It contains instructions to help you use and maintain your appliance properly.If you received a damaged appliance: Immediately contact the builder (or retailer) that sold you the appliance.Save time and money: Check the Troubleshooting section at the end of the guide before calling. This section helps you solve common problems that may occur.If you do need service, you can relax knowing help is only a phone call away.

Tel: 1-800-26(1-800-263-2629)

IMPORTANT SAFETY INFORMATIONREAD AND FOLLOW ALL SAFETY INSTRUCTIONSThis appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electrical shock by providing an escape wire for the electrical current.

SAFETY PRECAUTIONS

  1. The power source must be suitable for the standards of the ice maker. If the voltage f actuates by more than +/- 10% of therated 120 volts, the ice maker may not work correctly.
  2.  Hazardous materials such as explosive and f flammable materials, corrosive acid, and alkali materials cannot be used with or placed near the ice maker.
  3. If the power cord/plug is damaged stop using the ice maker. The cord and plug must be replaced by a professional.
  4.  Unplug the plug directly from the socket; Never pull on the cable to unplug.
  5.  Do not use the ice maker where coal is burning or an f ammable gas could be leaking.
  6.  Before cleaning or performing any kind of maintenance, remember to unplug the unit from the power source.
  7.  The ice maker is specially designed for making ice cubes only; do not use it to refrigerate food or beverages.
  8. Unplug the cable from the power source before moving the ice maker to avoid any damage to the refrigerating system.
  9. To avoid personal injury do not take apart ice maker under any circumstances. Service must be performed by a professional.
  10. Only use the appliance for its intended purpose. This unit is not intended for use by children. Do not allow children to operate the unit unsupervised.

INSTALLATION INSTRUCTIONS

LOCATION

  1.  Place the ice maker securely upon a sturdy and level surface.
  2. Position the unit away from any sources of heat and avoid direct sunlight, so as not to impact the ice-making performance.
  3. Ensure that there is a minimum unobstructed space of 20cm (7.87″) from the ice maker’s air outlet and inlet.
  4. The ambient temperature for ice makers can not be less than 5°C (41°F).
  5. This ice maker cannot be used outdoors.

FEATURES

1. Ice-making status is watched through the transparent window.2. Push-button operation. LED indicator light indicates the mode.3. Automatic beeping functions indicate water shortage, ice bucket fullness, or cleaning cycle ensuring the ice maker is always working properly.

1 Transparent window2 Cover3 Operation panel4 Air outlet5 Air inlet 6 Power cord7 Water outlet drain8 Ice bucket9 Evaporator10 Ice making box

OPERATING INSTRUCTIONS

PREPARATION BEFORE USE

  1.  Remove and properly discard of all packaging.
  2. Make sure you have all the accessories and instructions.
  3. Place the ice maker in a suitable position (according to previous instructions)
  4. Clean the machine before use (according to directions on page 4 & 5)
  5. Turn on the self-clean mode before you use your ice maker for the f rst time. (see Self-Clean Mode operation on page 5)

USING THE ICE MAKER

1. Do not switch on the power source to the ice maker within 30 minutes after moving the ice maker to allows the oil in the compressor to settle back into the compressor if the unit was tipped.2. Pour water into the water tank to the “Max Fill Line” (see Fig.A on page 5). You must use potable water (safe to drink water) to make ice.3. Press the key to start making ice.CONTROL PANEL

Buttons and Icons

Functions
Button Start operation, Standby, Clear faults/ Turn off the unit.
SELECT Button Select ice cube size
ON indicator Power indicator
Bucket full indicator Indicates ice cube fullness.
Add Water indicator Indicates water shortage, need to add water.
Large indicatorMedium indicatorSmall indicator – Three ice cube sizes. – Large, Medium, Small.(Default setting is Med)

 

CARE AND MAINTENANCE

CLEANING INSIDENOTE: Be certain the power is off before cleaning any part of this appliance.

  1. Make sure to unplug the appliance before cleaning.
  2.  Make sure to unplug the appliance before long-term storage.
  3.  Cleaning the water tank:1). Unscrew the nut and remove the rubber plug from the water outlet, drain out all of the water.2). Use clean warm water and a cloth to clean inside the ice bucket. Flush unit with clean water until the water f owing out is clear. Drain all water and reinstall rubber plugs and retighten the nut.
  4. Do not use solvents, boiling water, cleaning agents, strong acids or strong Alkali substances for cleaning.
  5. If the ice maker will not be used for a long time, you should unplug it, drain out all water dry the appliance with a clean cloth and store the ice maker in a clean place.
  6. When you’re finished making ice, drain the excess water out of the unit. Do not allow the same water to sit in the unitovernight or for extended periods of time.

HELPFUL HINTS

• Allow the ice maker cover to remain open for a few minutes after the ice-making process is complete.• Walls, Floor of the bucket, Inside Window, and Plastic Parts – Some water deposits and dust can be removed with a paper towel, others may require a damp cloth.• Ice Bucket – The ice bucket can be broken if dropped. Remember, do not operate the ice maker without the ice bucket in place. Do not use abrasive cleaners or sharp utensils on any part of your ice maker.

CLEANING THE OUTSIDEOUTER CASE – Clean the outside of the appliance with a soapy cloth. Rinse and then dry. Wipe the window clean with a damp clean cloth.CONTROL PANEL AND DOOR – Wipe with a damp cloth. Dry thoroughly. Do not use cleaning sprays, large amounts of soap and water, and abrasive or sharp objects on the panel. They can damage it. Some paper towels can also scratch the control panel.COVER SURFACE – It’s important to keep the area clean where the door seals against the cabinet. Use only mild, non-abrasive detergents applied with a clean sponge or soft cloth. Rinse well.SELF-CLEAN MODE OPERATIONThe self-clean model should be completed before you use your ice maker for the f rst time and/or if there has been a long period without use. The three LED lights for  POWER, ICE FULL, ADD WATER will be on at the same time when the ice maker is in self-clean mode.Stage 1

  1. Add equal parts of water and vinegar (1:1) to the ice maker’s reservoir.
  2.  In standby mode, hold the ON/OFF button for at least 5 seconds to activate the self-clean mode. Please note that self-clean mode will start automatically after a “Beep” sound.
  3. During self-clean mode, the upper water bucket is f fled and evacuated. The pump will remain in continuous operation as it feeds water to the bucket and evaporator coils. This cycle will run continuously f ve times.
  4. Upon completion, the unit automatically changes back to stand-by mode.Stage 2

 

  1. Drain the cleaning solution from the internal reservoir by removing the rear drain cap and plug.
  2. Add fresh water to the Max f ll line. See Fig.AFig.A
  3. In standby mode, hold the ON/OFF button for at least 5 seconds to activate the self-clean mode again which will now act as a rinse.
  4.  Upon completion of this f final stage of the self-clean process, the unit automatically changes back to stand-by mode.Proceed to drain the water from the internal reservoir by removing the rear drain cap and plug. Leave the lid on the ice maker open to allow it to air dry. The vinegar smell will dissipate quickly. Please note that if there is a water shortage during the self-cleaning mode, the unit will automatically go into standby mode;
  5. If the water bucket fails to turn over, ICE FULL, and ADD WATER LED lights will be fashing at the same time. You need to press and hold the ON/OFF button for  more than 5 seconds to deactivate the self-cleaning mode in order to change operation settings. Do not allow the evaporator to soak in the cleaning solution for an extended period.

TROUBLESHOOTING

Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this troubleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s Toll-Free Number 1-800-263-2629 for assistance.

 

PROBLEM POSSIBLE CAUSE

SOLUTION
The POWER indicator does not illuminate. The power source is a riot on. 1Check if the power supply is appropriate. 2. Check if the power cord is connected properly to the unit and power supply.

3. Internal components may be damaged. Maintenance by a professional is required.
ICE FULL indicator is on 1. Ice is full.

2. Temperature is lower than 5C.

 1.  Remove the ice.

2. Move the ice maker to a warmer place where the ambient temperature is higher than SC.
ADD WATER indicator is on. Water shortage. 1.  Add drinkable water into the ice maker. and press the button.

2.  Water supply system may be damaged. Maintenance by a professional is required.
ICE FULL indicator and ADD WATER indicator are both on. Ice making box is in an incor- rest position. 1. Check whether any foreign object is stuck in the ice-making box.

2. Internal components may be damaged. Maintenance by a professional is required.
Not making ice or not per- forming well. 1.  Heat output is blocked.

2.  Water temperature is too high.

3.  Ambient temperature is too high.

4.  Refrigerant leaks.

 1.   Clean any dust off the air inlet and outlet.

2.   Fill with room temperature water.

3.  Move the ice maker to a warmer place where the ambient temperature is higher than SC.

4.  Refrigerating system may be damaged. Maintenance by a professional is required.
Abnormal noise Fan or pump is obstructed. 1. Set up the appliance in the proper location (see page 3)

LIMITED APPLIANCE WARRANTY

This quality product is warranted to be free from the manufacturer’s defects in material and workmanship, provided that the unit is used under the normal operating conditions intended by the manufacturer. This warranty is available only to the person to whom the unit was originally sold by Danby Products Limited (Canada) or Danby Products Inc. (U.S.A.) (hereafter “Danby”) or by an authorized distributor of Danby, and is non-transferable.

TERMS OF WARRANTY

Plastic parts are warranted for thirty (30) days only from the purchase date, with no extensions provided.

First Year During the first twelve (12) months, any functional parts of this product found to be defective will be repaired or replaced, at the warrantor’s option, at no charge to the ORIGINAL purchaser.
To obtain Service It will be the consumer’s responsibility to transport the appliance (at their own expense) to the original retailer (point of purchase) or a service depot for repair. Contact your dealer from whom your unit was purchased, or contact your nearest authorized Danby servdepot, where service must be performed by a qualified service technician. If service is performed on the unit by anyone other than an authorized service depot, or the unit is used for commercial application, all obligations of Danby under this warranty shall be void.

Nothing within this warranty shall imply that Danby will be responsible or liable for any spoilage or damage to food or other contents of this appliance, whether due to any defect of the appliance, or its use, whether proper or improper.EXCLUSIONSSave as herein provided, Danby, there are no other warranties, conditions, representations or guarantees, express or implied, made or intended by Danby or its authorized distributors and all other warranties, conditions, representations or guarantees, including any warranties, conditions, representations or guarantees under any Sale of Goods Act or like legislation or statue is hereby expressly excluded. Save as herein provided, Danby shall not be responsible for any damages to persons or property, including the unit itself, howsoever caused or any consequential damages arising from the malfunction of the unit and by the purchase of the unit, the purchaser does hereby agree to indemnify and hold harmless Danby from any claim for damages to persons or property caused by the unit.GENERAL PROVISIONSNo warranty or insurance herein contained or set out shall apply when damage or repair is caused by any of the following:1)Power failure.2)Damage in transit or when moving the appliance.3) improper power supply such as low voltage, defective house wiring, or inadequate fuses.4)Accident, alteration, abuse, or misuse of the appliance such as inadequate air circulation in the room or abnormal operating conditions (extremely high or low room temperature).5)Use for commercial or industrial purposes (ie. If the appliance is not installed in a domestic residence).6)Fire, water damage, theft, war, riot, hostility, acts of God such as hurricanes, floods, etc.7)Service calls resulting in customer education.8)Improper Installation (ie. Building-in of a free-standing appliance or using an appliance outdoors that is not approved for outdoor application).Proof of purchase date will be required for warranty claims; so, please retain the bill of sale. In the event warranty service is required, present this document to our

AUTHORIZED SERVICE DEPOT.Warranty ServiceCarry-InDanby Products LimitedPO Box 1778, Guelph, Ontario, Canada N1H 6Z9Danby Products Inc1-800-263-2629PO Box 669, Findlay, Ohio, U.S.A. 45840Telephone: (519) 837-0920 FAX: (519) 837-0449Telephone: (419) 425-8627 FAX: (419) 425-862904/09

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,