DIGITUS DA-70618 Rev. 2 Charger Box (2x USB A, 1x USB Type-C) User Manual
Package Content
- 1x Main unit
- 1x User Manual
Energy Efficiency
Input: 230~, 50Hz, Max 0.3 AOutput: total 5.0Vd.c 3.1A, Max. 15.5 WFor Type A
- 5.0Vd.c. 2.4, Max. 12.0 W
- Average active efficiency: 82.8 %
- Efficiency at low load (10%): 75.0 %For Type C
- 5.0Vd.c. 3.0, Max. 15.0 W
- Average active efficiency: 82.8 %
- Efficiency at low load (10%): 75.0 %No-load power consumption: 0.09
Connections
- Turn power off before installation.
- To connect the base as shown in Diagram A before installing in into the mounting boxes, make sure there is no wire exposed at the connection. Note the phases cannot be ground trough to another safety wall outlet nearby. We recommend installing the safety outlet at the end of the row.(ATTENTION: the cross-sectional area of wire connect power is at least 1.5mm^2 not exceed 2.5mm^2）
- To fix the base by the screw or claw as Diagram B or Diagram C, then put the frame onto the base.
3.1 FOR:
- DO NOT OVERLOAD.
- To install the product needed by a qualified electrician.
- The symbol in manual
For indoor use only
SMPS (switch mode power supply unit)
SMPS incorporating a Short-circuit-proof safety isolating transformer (inherently or non-inherently)
Symbol for class II
Protective earth
Protective earth
Warning
- For your safety, please read the following cautions before installing or using your device.
- Do not open the device or attempt to repair it.
- Use the device in a dry location, and avoid placing it in a humid environment.
- Do not submerge the device in liquid or attempt to clean it with liquids or solvents. To clean the device, disconnect it from the power outlet and use a damp towel.
- This device should only be used indoors.
- USB Charger Adaptor for IT-equipment: do not exceed the total max output from both USB outputs.
- Only use the device within the specified temperature range for: 0 ~ 40°C
- Do not let the indoor devices come into contact with liquids.
- During thunderstorms, there is a danger of lightning strike and due to overvoltage damage to connected electrical appliances.
- Do not install the product during a thunderstorm.
- Disconnect the product from power source during a thunderstorm.
- Keep the devices outside the reach of children, since these components can be dangerous.
- Never try to repair the device by yourself. Repair and maintenance work must be carried out by specialists.
- In case of problems contact our customer service.
- Dust, humidity and vapours as well as sharp cleaning agents or solvents can damage the product.
Hereby Assmann Electronic GmbH, declares that the Declaration of Conformity is part of the shipping content. If the Declaration of Conformity is missing, you can request it by post under the below mentioned manufacturer address.
www.assmann.comAssmann Electronic GmbHAuf dem Schüffel 358513 LüdenscheidGermany
References
[xyz-ips snippet=”download-snippet”]