DIGITUS DN-7042-1 Rev.3 Wireless 150N USB 2.0 Adapter Installation Guide

WIRELESS 150NUSB 2.0 ADAPTER

Quick Installation GuideDN-7042-1 Rev.3

Driver Installation

Please follow the following instructions to install your new wireless USB Adapter:

1. Insert the USB wireless network card into an empty USB 2.0 port of your computer, when the computer is switched on. Never use force to insert the card, if you feel it’s stuck, flip the card over and try again.
2. The following message will appear on your computer, click `Cancel / Close‘.Windows 7/8/10
3. Insert the driver CD into your CD-ROM. You can see the auto-run screen below. If not, you can double click `autorun.exe‘ on CD.Click `Install Driver‘ to start the installation procedure
4. Installation descriptions showed. Click `Next‘ to continue
5. Once the installation is finished the computer will be asked to reboot. You can click `Finish‘ and reboot the computer to finish the installation of driver files
6. Insert the USB wireless network card into a USB 2.0 port of your computer, the system will find the new hardware and will install the drivers automatically.
7. After finishing driver installation, click adapter utility from your taskbar or programs folder. Click “available networks“, select the wireless access point you would like to connect and press the “Add to Profile” button.
8. Fill in the security information if any requirement, and then click “OK” to connect the wireless network.
9. Connected successfully. It will show the status screen.

DN-7042-1Technical Description Frequency

The manual content may be changed. Please also refer to the latest version on the webshop.Hereby Assmann Electronic GmbH declares that the Declaration of Conformity is part of the shipping content. If the Declaration of Conformity is missing, you can request it by post under the below-mentioned manufacturer address.www.assmann.comAssmann Electronic GmbHAuf dem Schüffel 358513 LüdenscheidGermany

References

• 
  ASSMANN Electronic GmbH | Germany