DODOELEPHANT RC Car UD2196A Instruction Manual

DODOELEPHANT RC Car UD2196A

Thanks for your using. In order to know about our products better. please read this manual carefully before using.

Note

  • Electronic control productThis product is suitable for children aged six or above. Please pay attention to and prevent electric shock when using electronic products.
  • Please use the product under the supervision of adults.Warning: Please do not disassemble or modify this product, or it may not function properly due to any change.

Note

  1. The remote control requires 2 1.SV AA non-rechargeable batteries.
  2. The car requires one piece of 6V AA rechargeable battery.
  3. Pay attention to the polarities and types when loading batteries.
  4. Non-rechargeable batteries are not to be recharged.
  5. Product contact for 20 minutes
  6. The supply terminals are not to be short-circuited.
  7. Adult supervision required when charging.
  8. Check the cord, plug, power switch, enclosure and other parts regularly. Please do not use them if there is any damage.
  9. When the car is not in use, please make sure that the power switch is “OFF” and remove the batteries in the car body and remote control.
  10. This product is made of plastic and metals. avoid immersing the batteries in the water.
  11. There may be little difference between object and picture. please adhere to the actual product instead.
  12. The package contains important information. please keep it properly for future reference.

Precautions on Watch- control

  1. Lights line up one by one on the panel: ON/OFF -White Light-Green Light-Blue Light-Red Light;
  2. Keep pressing the panel switch for 2s to switch on the panel. When it is under the state of decoding, the white light, green light and blue light (hereinafter called 3 lights) will be flashing slowly at the same time.
  3. Shortly press the panel, the 3 lights deadlocked will keep eternal bright “ON”. When unlocked, the 3 lights will be flashing slowly, flashing slowly with function.
  4. The red light is the charging indicator. It will keep bright “ON” eternally during the course of charging. When it is fully charged, it will be “off”.
  5. When it is under the insufficient power, the green light and the blue light won’t be “ON”.

2.4G signal connection introduction

  1. Place the batteries in the remote control, and the indicator light of remote control will star flashing. Load battery in the car and switch it on, and began to signal connect. When the signal connection is completed, the indicator light of remote control will turn off.Note: if the signal connection fails, please repeat the above operation.
  2. One remote control used to connect with one car only when the signal connection is completed the car drives without any interference.Note: multiple connections at the same time are not allowed.
  3. When the remote control fails to find the Car’s 2.4G signal in 1 minute, it will enter to sleep mode (indicator light is off), press any button to exit the sleep mode.
  4. light is off), press any button to exit the sleep mode.
  5. When match with the same type of other remote control or car, please turn off the remote control and car.

Product configuration

Part designations

How to install battery

Remote control

  1. Remove the battery cover of remote control and load the AA batteries into the battery box according to the polarity indication on the battery box.
  2. Attach the battery cover.

Instruction on how to assemble the RIC Car and how to load the chargeable battery in the watch. RIC Car

  1. Open the battery cover at the base of the car and then please connect the chargeable battery with the power socket. Load the chargeable battery into the battery compartment at the base of the car.
  2. Close the battery cover and tightly wrench by screwdriver.
  3. Watch plug-in charging.

RC car

  1. Remove the battery cover of the car bottom connect the rechargeable battery pack to the power socket and put it into the battery box.
  2. Reattach the battery cover and fasten it with screwdriver.

Wear a remote watch

  1. Aim the watch hole to the thumb and put into the watch.
  2. Please simply buckle it by aiming at the holes of the watch belt.
  3. Finger key is on the belt, just keep pressing the finger keys to control.

Demonstration illustration of gesture operation

  1. Keep pressing the finger key and swing upward is for twisting upward.
  2. Keep pressing the finger key and swing downward for twisting downward.
  3. Press the fist is for advancing forward.
  4. Tilt the fist upward is for running backward.
  5. Tilt the fist to the left is for racing to the left.
  6. Tilt the fist to the right is for racing to the right.

Operation tips

  • Please make sure that the power switch is “ON” when the vehicle is being operated. When the power switch is “OFF”, the car is turned off.
  • When the battery is low, it will affect the left/right turning and slow down forward/backward is range.
  • The effective control range of the RC car is about 40 meters. The car will stop running or be out of control if beyond this range.
Common fault    processing
Problems Causes Solutions
 

 

 

The car has no response

  

1. The remote control fails to connect, or the car is on “OFF”.

2. The remote control and remote control car batteries are installed improperly.

3. The power of the rechargeable battery pack is weak.

  

1.Turn on the car and repeat the operation of signal connection.

2. lnstall the batteries according to the polarity instructions on the battery box correctly.

3. Please full charge  the battery pack.
The car is out of control. or the control range turn short. 1. The batteries of the remote control is low, or the power of the battery pack is weak.

2. There may be interference near the site.

 1.Replace with new batteries for the remote control. or charge the battery pack.

2..Replace the battery
 

Exception protection

 1.The car is hindered by external force and the function of the car can not be completed, or the electronic circuit is short-circuited. 1.Turn on the power again, Remote control car power protection.

How to charge battery pack

  1. The new battery pack need to be charged before use.
  2. Insert the plug of the battery pack to the port of the USB charging cable and connect the USB charging cable plug to the socket.
  3. The charging time is 2-3 hours. The indicator light of the USB charging cable turn red when charging, and turn off when fully charged. Do not over charge, it will not change battery capacity limit.
  4. Check the car, battery, charging cable, plugs and other parts regularly.
How to control the car
  1. Turn on the car.
  2. Push the direction lever of the remote control to let the car run forward/backward or tum left/right.
  3. When the car is not in use, please turn off the power of the car.
  4. When the driving is ended turn off the power of the car and the remote control will enter into sleep mode automatically.

InstructionsInstructions shall state that battery chargers used with the toy are to be regularly examined for damage to the cord and other parts, and in the event of such damage, they must not be used until the damage has been repaired.

Maintenance instruction

  1. .Do not close to the fire source and keep away from direct sunlight and high temperature and humidity such will avoid short-circuit or electrical fire.
  2. Take out the battery from the car and remote control and put the car and remote control into the package to avoid the damage when transporting or being in storage.
  3. Use dry and soft cloth to clean the car.

Warm tips

  • When the car moving please do not touch the wheels of the car and avoid injury.
  • Do not play on the road or in dangerous places in case of an accident.
  • Do not play the car in the sump.
  • Twisting forward or backward is HIGHLY FORBIDDED so as not to wring the inner parts.

To consumers

  1. Be careful not to cause damage to the furniture or glass when playing the car in the room.
  2. Play in the safe outdoor environments.do not play the car on road or in crowd for safety.
  3. When play the car in the outdoors, please stop playing when hear the thunder.
  4. Do not reach the rotating wheels to avoid injury Prevent things like hair and clothes from getting caught in the wheels.
  5. Do not drive the car toward to people.
  6. The car is made of complex electronic circuits and electronic components, do not disassemble or modify the circuit board.
  7. If the car is dirty please clean it with dry and soft cloth.
  8. Do not put the toys in the water otherwise, the electronic parts will be damaged.

Safety guide

  1. To ensure the electromagnetic environment requirement of the aviation radio (station), using remote controls in the zone, which is in a radius of about 5000m zone from the circle center of the airport runway, is forbidden. All users also should abide by the regulation of the radio set forth by government and regulatory agencies including the duration and area.
  2. Never look steadily at the laser beam since the laser radiation.

858)768-9731[email protected](US)[email protected](EU)www.dodoelephant.com

report this ad

Manufacturer: Shantou Chenghai ZhengguangPlastic Toys Co., Ltd.Address: Shangcun Industrial Zone, Lianxia Town, Chenghai District, Shantou City, Guangdong, China

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,