DOMETIC Air Break Pro 3/5 Awnings Windbreaks Installation Guide

DOMETIC Air Break Pro 3/5 Awnings Windbreaks

© 2021 Dometic Group. The visual appearance of the contents of this manual is protected by copyright and design law. The underlying technical design and the products contained herein may be protected by design, patent or be patent pending. The trademarks mentioned in this manual belong to Dometic Sweden AB.All rights are reserved.

Air Break Pro 3/5 Awnings Windbreaks

Please read these instructions carefully and follow all instructions, guidelines, and warnings included in this product manual in order to ensure that you install, use, and maintain the product properly at all times. These instructions MUST stay with this product.By using the product, you hereby confirm that you have read all instructions, guidelines, and warnings carefully and that you understand and agree to abide by the terms and conditions as set forth herein. You agree to use this product only for the intended purpose and application and in accordance with the instructions, guidelines, and warnings as set forth in this product manual as well as in accordance with all applicable laws and regulations. A failure to read and follow the instructions and warnings set forth herein may result in an injury to yourself and others, damage to your product or damage to other property in the vicinity. This product manual, including the instructions, guidelines, and warnings, and related documentation, may be subject to changes and updates. For up-to-date product information, please visit documents.dometic.com, dometic.com.

Explanation of symbols

CAUTION!Safety instruction: Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury.
NOTICE!Indicates a situation that, if not avoided, can result in property damage.
NOTESupplementary information for operating the product.

General safety instructions

CAUTION! Failure to obey these cautions could result in minor or moderate injury.

Risk of injury

  • This device is not intended for use by persons(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the device by a person responsible for their safety.
  • Do not allow children to play around the windbreak and ensure that suitable protective footwear is worn. Guy lines are a trip hazard and pegs can be sharp.
  • Cleaning and user maintenance may not be carried out by unsupervised children.

Scope of delivery

Component Quantity
AIR BREAK 1
Peg pack 1
Carry bag 1

Intended use

The AIR BREAK is suitable for:

  • Connecting to an awning
  • Freestanding
  • Light to moderate weather
  • Touring

The AIR BREAK is not suitable for:

  • Very strong winds or snowfall
  • Seasonal pitch* or commercial use* All-Season models have been designed for use on seasonal pitches.

This product is only suitable for the intended purpose and application in accordance with these instructions.

This manual provides information that is necessary for proper installation and/or operation of the product. Poor installation and/or improper operating or maintenance will result in unsatisfactory performance and a possible failure.The manufacturer accepts no liability for any injury or damage to the product resulting from:

  • Incorrect assembly or connection, including excess voltage
  • Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
  • Alterations to the product without express permission from the manufacturer
  • Use for purposes other than those described in this manual

Dometic reserves the right to change product appearance and product specifications.

Using the windbreak

CAUTION! Risk of injury and material damageNever open the zipper on the protective sleeve while an air pole is inflated. This will result in the air pole bursting

Before first use

Familiarize yourself with the product by carrying out a test set up before the product is used for the first time. Check if the scope of delivery is complete.

Choosing a site

  1. Choose a flat site.
  2. Choose a shaded site to avoid UV degradation of the fabric.
  3. Avoid pitching under trees as falling branches, resin, etc. can damage the product.
  4. Clear the site of sharp stones and debris.
  5. If used freestanding, set up the windbreak with the opening facing away from the wind.

Setting up the windbreak

CAUTION! Risk of injury and material damage

  • Do not use any type of compressor designed to inflate car tires.
  • Only inflate the air poles into the green zone of the pressure gauge of the hand pump supplied with the main awning (9 psi/0.62 bar).
NOTICE! Material damageDo not open or close the zippers by force.
NOTE

  • The supplied pegs will be suitable for many sites but for some types of ground special pegs will be needed. Ask your dealer.
  • Drive the pegs at a 45° angle away from the windbreak into the ground.
  • Peg the guy lines in line with the seam they start from.

 

Keep the following tips in mind while setting up the windbreak:

  • The illustrations provide a general overview of the set-up. The actual set-up will vary slightly based on the model of windbreak.
  • Get help. The set-up is easier with more people.
  • Peg the guy lines so that the windbreak is under tension without distorting the shape.
  • Check the guy lines from time to time to ensure adequate tension, if necessary use the runners to adjust.

Set up the windbreak as follows:

  1. To protect the windbreak from dirt and damage, lay down a groundsheet or footprint before unpacking.
  2. Unpack the windbreak.
  3. Separate and identify the different components.
  4. Proceed as shown to set up the windbreak (fig., to  fig.Check above).If you use the windbreak freestanding:

➤ Proceed as shown to set up the windbreak (fig., to fig.Check above).

Dismantling the windbreak

  1. Remove all dirt from the windbreak.
  2. Unpeg all pegging points and unclip all guy lines.
  3. Deflate the windbreak (fig., Check above).
  4. Fold/roll the windbreak towards the valves to expel more air.
  5. When deflated, roll the windbreak to fit into the carry bag.
  6. Zip and tighten the compression straps.
  7. Ensure that all parts are clean before packing them into the carry bag.
  8. If the windbreak is wet or damp, dry fully as soon as possible.

Cleaning and maintenance

NOTICE! Material damage

  • Do not use sharp or hard objects or cleaning agents for cleaning.
  • Do not use alcohol based materials, chemicals, soap and detergents for cleaning.
  • Remove bird droppings and tree resin as soon as possible to avoid permanent damage to the materials

1. If necessary, clean the product with clean water and a soft brush.2. Apply impregnation against water and UV radiation before each trip.

Storing the windbreak

NOTE

  • Fully set up the windbreak for cleaning.
  • Choose a sunny day for cleaning to ensure the material will dry thoroughly
  1. Clean the windbreak.
  2. Air fully and ensure the windbreak is totally dry before packing away.
  3. Store in a well ventilated dry place.

Troubleshooting

NOTE

A fully equipped spare parts kit should include:

  • waterproofer
  • repair tape and repair solution
  • silicone spray for the zippers
  • spare pegs

 

Problem Solution
Windbreak only inflates with difficulties ➤ Check that the valve is fully screwed into the air pole.➤ Check if the inflation tube is twisted at the valve. This may be indicated by noise. Untwist the inflation tube.➤ Check that the hand pump is working.
Air poles are kinked ➤ Add more air (9 psi/0.62 bar).
Air leak ➤ Check that the valve is fully screwed into the air pole and the ring seal is in place.➤ Check that the cap of the valve is done up tightly.
Rip in the fabric ➤ Use repair tape to seal the fabric.➤ Have repairs carried out by an authorized specialist.

Disposal

➤Place the packaging material in the appropriate recycling waste bins, wherever possible.

If you wish to finally dispose of the product, ask your local recycling center or specialist dealer for details about how to do this in accordance with the applicable disposal regulations.

Warranty

The statutory warranty period applies. If the product is defective, please contact the manufacturer’s branch in your country (see dometic.com/dealer) or your retailer.For repair and warranty processing, please include the following documents when you send in the device:

  • A copy of the receipt with purchasing date
  • A reason for the claim or description of the fault

The warranty covers manufacturing defects, materials and parts. The warranty does not cover fading of the cover and wear and tear due to UV radiation, misuse, accidental damage, storm damage, or permanent, semi-permanent* or commercial use. It does not cover any resulting damage. Please contact your dealer for claims. This does not affect your statutory rights.* All-Season models have been designed for use on seasonal pitches.

YOUR LOCAL DEALERdometic.com/dealer

YOUR LOCAL SUPPORTdometic.com/contact

YOUR LOCAL SALES OFFICEdometic.com/sales-offices

www.dometic.com

References

[xyz-ips snippet=”download-snippet”]