AWNINGS INFLATABLE AWNINGS
HUB
© 2021 Dometic Group. The visual appearance of the contents of this manual is protected by copyright and design law. The underlying technical design and the products contained herein may be protected by design, patent or be patent pending. The trademarks mentioned in this manual belong to Dometic Sweden AB. All rights are reserved.
HUB
1• Width: 230 cm• Depth: 230 cm• Height: 230 cm• Weight: 13.8 kg• Min weight: 12.3 kg |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
 |
 |
 |
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
|
 |
 |
 |
|
 |
Please read these instructions carefully and follow all instructions, guidelines, and warnings included in this product manual in order to ensure that you install, use, and maintain the product properly at all times. These instructions MUST stay with this product.By using the product, you hereby confirm that you have read all instructions, guidelines, and warnings carefully and that you understand and agree to abide by the terms and conditions as set forth herein. You agree to use this product only for the intended purpose and application and in accordance with the instructions, guidelines, and warnings as set forth in this product manual as well as in accordance with all applicable laws and regulations. A failure to read and follow the instructions and warnings set forth herein may result in an injury to yourself and others, damage to your product, or damage to other property in the vicinity. This product manual, including the instructions, guidelines, and warnings, and related documentation, may be subject to changes and updates. For up-to-date product information, please visit“documents.dometic.com, dometic.com”.Explanation of symbols
DANGER!Safety instruction: Indicates a hazardous situation that, if not avoided, will result in death or serious injury.
WARNING!Safety instruction: Indicates a hazardous situation that, if not avoided, could result in death or serious injury.
CAUTION!Safety instruction: Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury.
NOTICE!Indicates a situation that, if not avoided, can result in property damage.
NOTESupplementary information for operating the product.
Safety instructionsDANGER! Failure to obey this instruction will cause death or serious injury.Hazard of carbon monoxide poisoning• Never use a fuel-burning appliance such as barbecues or gas heaters inside the awning tent. The burning process produces carbon monoxide which accumulates inside the awning tent as there is no flue.
WARNING! Failure to obey these warnings could result in death or serious injury.Fire hazard
- Make sure you know the fire precaution arrangements on the site.
- Do not cook inside the awning tent or use open flames.
Beware of suffocation
- Make sure ventilation openings are open all the time to avoid suffocation.
CAUTION! Failure to obey these cautions could result in minor or moderate injury.Risk of injury
- This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack ofexperience and knowledge, unless they have been given supervision or instruction concerning the use of the device by a person responsible for their safety.
- Do not allow children to play around the awning tent and ensure that suitable protective footwear is worn. Guy lines are a trip hazard and pegs can be sharp.
- Cleaning and user maintenance may not be carried out by unsupervised children.
- Keep passageways clear.
Scope of delivery
| Component | Quantity |
| Awning tent | 1 |
| QuickPitch straps | 4 |
| Storm straps | 4 |
| Hand pump | 1 |
| Peg bag | 1 |
| Carry bag | 1 |
Accessories
|
Accessory |
Ref. No. |
| HUB Sleeping Annexe | 9120001507 |
| HUB PVC Window / Door Panel | 9120001508 |
| HUB Mesh Window / Door Panel | 9120001509 |
| HUB SUV Connect Tunnel | 9120001510 |
| HUB Campervan Connect Tunnel | 9120001511 |
| HUB Weight Bag | 9120001512 |
| Footprint | 9120001458 |
Intended use
This awning tent is suitable for:
- stand-alone use
- SUVs and campervans
- light to moderate weather
- touringThis awning tent is not suitable for:
- very strong winds or snowfall
- seasonal pitch or commercial use
This awning tent is only suitable for the intended purpose and application in accordance with this instruction. Any other use, deviating from the intended use, is not allowed! Dometic accepts no liability for any loss, damage or injury incurred, directly or indirectly due to others as the intended use.
Using the awning tent
CAUTION! Risk of injury and material damageNever open the zipper on the protective sleeve while an air pole is inflated. This will result in the air pole bursting.Before first useFamiliarize yourself with the product by carrying out a test setup before the product is used for the first time. Check if the scope of delivery is complete.Choosing a siteChoose a flat site that is protected from wind:
- If necessary, use a windbreak.
- Choose a shaded site to avoid UV degradation of the fabric.
- Avoid pitching under trees as falling branches, resin, etc. can damage the product.
- Clear the site of sharp stones and debris to avoid damaging thegroundsheet.
- Set up the product with the doors facing away from the wind.
Setting up the awning tent
CAUTION! Risk of injury and material damage
- Do not use any type of compressor designed to inflate car tires.
- Only inflate the air poles into the green zone of the pressure gauge of the supplied hand pump (9 psi/0.62 bar).
NOTICE! Material damage
- Do not open or close the zippers by force.
- If a wind-out awning is used to attach the awning tent, support the wind-out awning while working to avoid putting too much stress on it. After attaching the awning tent, rewind the wind-out awning fully back into its housing.
NOTE
- The awning tent comes with heavy-duty pegs. These will be suitable for many sites but for some types of ground special pegs will be needed. Ask your dealer.
- Drive the pegs at a 45° angle away from the awning tent into the ground.
- Peg the guy lines in line with the seam it starts from.
Keep the following tips in mind while setting up the awning tent:
- The figures provide a general overview of the setup. The actual set-up will vary slightly based on the model of the awning tent.
- Get help. The set-up is easier with more people.
- After standing the awning tent upright, check the corner pegs and repeat if necessary. The base of the awning tent should be taut and insquare shape.
- Peg the guy lines so that the awning tent is under tension without distorting the shape.
- Attach the storm straps.
- Check the guy lines from time to time to ensure adequate tension, if necessary use the runners to adjust.Set up the awning tent as follows:
- To protect the awning tent from dirt and damage, lay down a groundsheet or footprint before unpacking.
- Unpack the awning tent.
- Separate and identify the different components.
- Proceed as shown to set up the awning tent (fig.
2, page 3 to fig.9, page 4).
Set up the accessories as follows:
- To protect the accessories from dirt and damage, lay down a groundsheet or footprint before unpacking.
- Unpack the accessories.
- Separate and identify the different components.
- Proceed as shown to set up the accessories (fig.
10, page 5 to fig.25, page 9).
Dismantling the awning tentNOTICE! Material damageDo not use force when dismantling the awning tent. Otherwise, you might damage any material.
- Remove any dirt on the outside.
- Close all window blinds.
- Close all doors.
- Remove all accessories.
- Remove all lines and straps.
- Remove all pegs between the corner pegs.
- Open the outlet valves.
- Wait until most of the air has been expelled.
- Remove the four corner pegs.
- Fold/roll the awning tent towards the valve to expel more air.
- When deflated, roll the awning tent to fit into the carry bag.
- Ensure that all parts are clean before packing them into the carry bag.
- If the awning tent is wet or damp, dry fully as soon as possible.
Cleaning and maintenance
NOTICE! Material damage
- Do not use sharp or hard objects or cleaning agents for cleaning.
- Do not use alcohol-based materials, chemicals, soap, and detergents for cleaning.
- Remove bird droppings and tree resin as soon as possible to avoid permanent damage to the material.
- If necessary, clean the product with clean water and a soft brush.
- Apply impregnation against water and UV radiation before each trip.
Storing the awning tentNOTE
- Fully set up the awning tent for cleaning.
- Choose a sunny day for cleaning to ensure the material will dry thoroughly.
- Clean the awning tent.
- Air fully and ensure the awning tent is totally dry before packing away.
- Store in a well-ventilated dry place.
Troubleshooting
NOTE
- During first exposure to water, there may be some moisture at the seams. Through this moisture, the threads will swell and fill the holes that are created in the sewing process.
- A fully equipped spare parts kit should include:– waterproofer– repair tape and repair solution– silicone spray for the zippers– spare pegs
|
Problem |
Solution |
| Awning tent only inflates with difficulties | ➤ Check that the valve is fully screwed into the air pole.
➤ Check if the inflation tube is twisted at the valve. This may be indicated by noise. Untwist the inflation tube.➤ Check that the hand pump is working. |
| Part of the awning tent does not inflate | ➤ Check that all isolation valves that connect the air poles are open. |
| Part of the awning tent does not deflate | ➤ Check that all isolation valves that connect the air poles are open. |
| Air poles are kinked | ➤ Add more air (9 psi/0.62 bar). |
| Air leak | ➤ Check that the valve is fully screwed into the air pole and the ring seal is in place.
➤ Check that the cap of the valve is done up tightly. ➤ Check for punctures, see chapter “Repairing a puncture in the air pole” on page 12. |
| Water leak | ➤ Check for leaky seams, damaged tapings, and moist areas.➤ If you cannot find any leaks, see chapter “Condensation” on page 12.➤ If you find any leaks, apply a seam sealant. |
| Rip in the fabric | ➤ Use repair tape to seal the fabric.➤ Have repairs carried out by an authorized specialist. |
Condensation
All awning tents suffer from internal condensation if one or more of the following conditions apply:
- high air humidity
- high ground moisture
- a drop in temperature
Severe condensation can run down the inside of the roof and drip off ties, tapes, and other internal fittings and can be mistaken for leaking.➤ Increase ventilation by opening doors and/or windows.➤ Install a waterproof groundsheet.
Repairing a puncture in the air poleIf the air pole loses air, proceed as follows:
- Unzip the outer sleeve holding the air pole.
- If installed, close isolation valves.
- Remove the air pole.
- Deflate the air pole.
- Unzip the protective sleeve to expose the inflatable tube.
- Blow some air into the inflatable tube.
- Submerge the tube in water.
- Locate the puncture.
- Use repair tape and repair solution to seal the hole.
- Zip the inflatable tube back into the protective sleeve.
- Zip the air pole back into the outer sleeve.
Disposal
➤ Place the packaging material in the appropriate recycling waste bins, wherever possible.
If you wish to finally dispose of the product, ask your local recycling center or specialist dealer for details about how to do this in accordance with the applicable disposal regulations.
Warranty
The statutory warranty period applies. If the product is defective, please contact the manufacturer’s branch in your country (see dometic.com/dealer) or your retailer.For repair and warranty processing, please include the following documents when you send in the device:
- A copy of the receipt with purchasing date
- A reason for the claim or description of the fault
The warranty covers manufacturing defects, materials and parts. The warranty does not cover fading of the cover and wear and tear due to UV radiation, misuse, accidental damage, storm damage, or permanent, semi-permanent or commercial use. It does not cover any resulting damage. Please contact your dealer for claims. This does not affect your statutory rights.
4445103214
References
[xyz-ips snippet=”download-snippet”]