DOMETIC PW1100 Wall Mounted Awning Instruction Manual

DOMETIC PW1100 Wall Mounted Awning Instruction Manual

Safety instructions

Please observe the prescribed safety instructions and stipulations from the vehicle manufacturer and service workshops.

 WARNING! Failure to obey these warnings could result in death or serious injury.

Health hazard

  • This device can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the device in a safe way and understand the hazards involved.
  • Children must be supervised to ensure that they do not play with the device.

Scope of delivery

Scope of delivery

The PW1100 awning is suitable for installing on motorhomes or caravans.

The awning must only be used whilst the vehicle is stationary. Please observe the operating manual.

This product is only suitable for the intended purpose and application in accordance with these instructions.

This manual provides information that is necessary for proper installation and/or operation of the product. Poor installation and/or improper operating or maintenance will result in unsatisfactory performance and a possible failure.

The manufacturer accepts no liability for any injury or damage to the product resulting from:

  • Incorrect assembly or connection, including excess voltage
  • Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
  • Alterations to the product without express permission from the manufacturer
  • Use for purposes other than those described in this manual

Dometic reserves the right to change product appearance and product specifications.

Installing the awning

Installing the awning

During installation, observe the following general information

  • The mounting plates are bolted to the vehicle in the area of the rear hinge. In addition, they are glued with installation adhesive (e.g. Sikaflex®-221 or a similar product) to ensure the load is evenly spread and an optimal level of protection from moisture is maintained.
  • Observe the sealant manufacturer’s instructions.
  • Before installation, check the access to the screw joints. Make sure no cables or cabinets are damaged when drilling.
  • If you want to use an awning tent with the awning at a later date, ensure that the vent windows and hatches remain accessible with erected tent when choosing the awning size and installation position (fig. 5, page 1).
  • Carefully seal the drill holes to prevent moisture from entering the motorhome wall.
  • Do not open the awning or leave it unattended, before the awning has been fastened to the mounting rails (fig.8, page 1 to fig.i, page 2).
  • As part of the regular maintenance procedure, the screws on the rear hinge must be tightened up by a service partner (fig.7, page 1). Ensure the users of the vehicle are aware of this.

Select the location of the installation.In particular, check that there is enough space in the interior to mount the counter plates at the points where the screws will be.

Installing the crank bracket

Mount the mounting bracket for the crank at a suitable location inside the vehicle

Installing the mounting bracket (optional)

The mounting bracket must be installed if the awning is to be attached to the side of the vehicle when extended.

Select the location of the installation.

In particular, check that the support legs reach the installation location on the wall when the awning is extended.

Warranty

The statutory warranty period applies. If the product is defective, please contact your retailer or the manufacturer’s branch in your country (see dometic.com/dealer).

For repair and warranty processing, please include the following documents when you send in the product:

  • A copy of the receipt with purchasing date
  • A reason for the claim or description of the fault

Disposal

Place the packaging material in the appropriate recycling waste bins wherever possible.

If you wish to finally dispose of the product, ask your local recycling centre or specialist dealer for details about how to do this in accordance with the applicable disposal regulations.

 

References

[xyz-ips snippet=”download-snippet”]


Posted

in

by