Work Table Assembly Instructions
Top Shelf (1)Lower Shelf (1)Legs (4)Allen Screws (16)Allen Wrench (1)
Unpack and check to make sure all contents are complete.Please follow the steps and instructions below.
1.Turn the top shelf upside onto the floor Place the carton top underneath for padding to avoid scratching.
2. Assembly four legsInsert four legs into the leg sockets, then partially fasten the Allen screws.
3. Assembly the lower shelfSlide the lower shelf into the legs to desired height, at least 9″, so that the lower portion of the shelf will sit at least 6″ above the floor when assembled. Finish tightening all Allen screws.
4. All four legs can be adjusted for surfaces that aren’t completely level. Rotate the plastic foot pad to compensate for differences in floor surface.
5. Turn over the completed equipment stand and it is now ready to use.
WARNING
- Do not use the equipment stand if any screws are missing.
- Level adjust the stand when there is no equipment or items on the top under shelf.
- Mobile stands must be used with restraining device.
CLEANING
- To maintain the appearance and increase the service life, clean your equipment daily.
- Using a damp cloth, sponge dipped in soapy water to clean the outside of the equipment stand.
© 2018 DuraSteel All Rights Reserved
[xyz-ips snippet=”download-snippet”]