User Manual- Rapid Mix
Introduction:
The RapidMix receiver is high performance receiver designed for Machine EV3000 googles, with Google’s user interface, customer no need take off the goggles to set the receiver, all the setting can be done in the UI.Transitional Diversity receiver use a hardware stitch to choose strongest signal from two receivers, when the both signals is weak, the rapid switch will cause the image flickering.the image is still sharp and clear, also without latency.
Specifications:
Quick Start
- Remove the goggle RX bay door.
- Insert the RapidMix Receiver with care, make sure the pins is not offset
- Insert the RX bay door, make sure there is not sticker block the cooling holes.
- Install the antenna.
- Press the button on the left side of the goggles, rolI the wheel choose RF normal.
Dual Receiver set up
The poppies have dual receiver bay, customer and install two RapidMix in to the bay, each RapidMix receiver will merge the image, then poppies will handle the two signal, then the goggle will pet the most stable image.
Calibrate the RSSI
Even though the receiver is calibrated in the factory, but the receiver need re—calibrate after over time use. the receiver need synchronize the RSSI of each receiver, then can make sure the receiver get the best performance, to ca!!b rate the RSSI, you need Vol low the step blow:
- Remove the antennas
- turn of VTX, the turn on the goggles
- Press right button get into menu, then go to system menu, choose RSSI calibration, after calibration is done, the goggle will beep
Upgrade Firmware
- Take the receiver out, hold the boot button then connect the receiver to the computer.
- Computer will automatically install the driver , then computer Will show a new removable storage
- Copy the Firmware File to the folder. receiver Will installing the update at the same time. it will I takes about 60s to install the Firmware
Eachine RapidMix User Manual – Eachine RapidMix User Manual –
[xyz-ips snippet=”download-snippet”]