EcoDim LED dimmer phase cut-off RC User Manual

Manual

LED dimmer phase cut-off (R, C)

ECO-DIM.02

Attention:– Installing the dimmer on a mains voltage of 230V should be carried out by a qualified professional, taking into account the national regulations. Make sure that the electricity is switched off during all work.

ECO-DIM.02

Article number: ECO-DIM.02Type of LED dimmer: phase cut-off (R, C)Power: 0-150 WattOperation:  Pressure/rotary switchPackaging: Packed individually

Suitable cover plates:

√ Berker by Hager√ Busch-Jaeger√ GIRA√ JUNG√ Merten by Schneider√ NIKO√ PEHASuitable for:– 230V LED lamps *– Light bulbs– 230V halogen lamps– Low voltage lamps with electronic transformer

* Provided the LED lamps work on a trailing edge / trailing edge LED dimmer.

Installation

Step 1: Remove the knob and the cover plate.Step 2: Always make sure that the electricity is switched off during installation. Then connect the wires as indicated in the ‘Connection diagram’.Step 3: Now install the dimmer in the mounting box.Step 4: Switch the electricity back on. Switch the connected lights on using the dimmer shaft. Now adjust the MIN/MAX, as described under ‘MIN/MAX installation’Step 5: Place the cover plate and dimmer knob back onto the dimmer.

Connection diagram

MIN/MAX adjustment

Use the MIN/MAX meter to set the minimum and maximum light output and light stability.

Min. light output adjustment:

Switch the light on using the dimmer shaft. Then turn the dimmer to the left as far as possible (minimum light output). Are the bulbs blinking? Then turn the MIN pot meter slowly to the right with a screwdriver for stable light. Has the light become stable already? Then turn the MIN slowly to the left for an even better dimmability, to just before the point where the bulbs start blinking. This is the best dimmability for these LED bulbs.

Max. light output adjustment:

Switch the light on using the dimmer shaft. Then turn the dimmer to the right as far as possible (maximum light output). Are the bulbs blinking? Then turn the MAX pot meter slowly to the left with a screwdriver for stable light in the maximum light position. Has the light become stable already? Then turn the MAX to the right for the maximum light output of these LED bulbs.