Energizer Motion-Activated LED Wall Sconce User Guide

Energizer Motion-Activated LED Wall Sconce

BATTERY INSTALLATION:

This product requires 6 AA batteries to function (sold separately).

  1. Remove the battery cover.
  2. Insert 6 AA batteries, noting polarity.
  3. Replace the battery cover.IMPORTANT: Different types of batteries or new and used batteries should not be mixed. Exhausted batteries should be removed from the fixture and disposed of properly.

MOUNTING INSTRUCTIONS:

  1. Lightly mark the screw locations with a pencil using the included mounting template.
  2. Use a 3/16”drill bit to pre-drill holes for the anchors.
  3. Seat the anchors into the pre-drilled holes.
  4. Insert each screw and fasten them in place with a screwdriver. Leave the screw heads protruding approximately 1/8” from the surface.
  5. Align the mounting holes on the sconce with the screws and fully mount the product onto the surface.

OPERATION:

Use the ON/AUTO/OFF switch on the side of the sconce to select your preferred setting.ON: The light remains ON until the batteries are depleted.AUTO: The built-in motion sensor activates the light when motion is detected within 15ft. After 20 seconds of inactivity, the light will turn OFF. The light also has a dusk-to-dawn feature that makes that light only turn on in low light conditions.OFF: The light is inactive and battery power will not be used.

©2020 Energizer. Energizer and certain graphic designs are trademarks of Energizer Brands, LLC and related subsidiaries and are used under license by Jasco Products Company, LLC.Contact our U.S.-based Consumer Care at 1-800-654-8483 between 7AM-8PM CST. 90-day warranty. Visit www.byjasco.com for warranty details.

References

[xyz-ips snippet=”download-snippet”]


Posted

in

by