EnGenius Outdoor Access Points
I - Getting Started
This kit comes with 2 EnGenius Outdoor Access Points with all the accessories for two units. Please reference the Quick Start Guide (QIG) in the box for a full breakdown of each part and quantity.
II - IP addresses and Serial Numbers
This kit comes with a unit pre-configured as Access Point Mode (AP), and the other unit pre-configured as Client Bridge mode (CB). The unit with the serial number with a hyphen 1 is the AP and the unit with the hyphen 2 is the CB. For example, the unit with serial number xxxxxxxx-1 would be the AP unit, and the unit with serial number xxxxxxxx-2 would be the CB unit. See figure 1 below. Please note that the IP address of the AP unit will be 192.168.1.1 and the IP address of the CB unit is 192.168.1.2. This IP address scheme is the same after a factory reset as well.
Figure 1: Serial Numbers Mode IdentificationMaximum data rates are based on IEEE 802.11 standards. Actual throughput and range may vary depending on the distance between devices or traffic and bandwidth load in the network.
III - Topology
This kit was pre-configured for a Point to Point (PtP) type of deployment. We recommend that the device acting as AP be located closest to the Demarc (internet access or NVR). The CB should be located at the remote end.
Figure2: AP to CB Topology
IV - Setup Video
For information on how to set up these units please see the video below:https://youtu.be/VP2hIZOue8M
EnGenius Technologies | 1580 Scenic Ave. Costa Mesa, CA 92626Email: [email protected] | Website: engeniustech.comVersion 1.20 05/12/2020Features and specifications subject to change without notice. Trademarks and registered trademarks are the property of their respective owners. For the United States of America: Copyright ©2020 EnGenius Technologies, Inc. All rights reserved.
References
[xyz-ips snippet=”download-snippet”]