Ultrasonic Humidifier Manual
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT TIP
IMPORTANT TIP: DO NOT leave the humidifier plugged in for prolonged periods (i.e. several days or more) without use. This causes premature failure of the circuitry. When the humidifier is not in use, turn the knob to the OFF position, then UNPLUG it.
Fig. 1OFF POSITION
Fig. 2UNPLUG FROM POWER SOURCE
We’re experts in improving indoor air quality, and our ultrasonic humidifier will dissipate dryness and increase moisture wherever you choose to use it. To ensure optimal performance, please read this guide carefully before use. The ultrasonic humidifier atomizes water into ultra-fine particles using the principle of ultrasonic high-frequency oscillation and diffuses water into the air through a pneumatic device to evenly humidify the air.
COMPONENTS
Fig. 3EXPLODED DIAGRAM
Fig. 4TOP VIEW OF BASE
Fig. 5TOP VIEW
Fig. 6CONTROLS
SAFETY (PLEASE READ CAREFULLY BEFORE USE)
- IMPORTANT TIP: DO NOT leave the humidifier plugged in for prolonged periods (i.e. several days or more) without use. This causes premature failure of the circuitry. When the humidifier is not in use, turn the knob to the OFF position, then UNPLUG it.CONSEIL IMPORTANT: Ne laissez pas l’humidificateur branché pendant de longues périodes (c’est-à-dire plusieurs jours ou plus) sans utilisation. Cela provoque une défaillance prématurée des circuits. Lorsque l’humidificateur n’est pas utilisé, tournez le bouton en position d’arrêt et débranchez-le.
- Thoroughly inspect the unit in its entirety for any cracks, chips, or damage that could cause the unit to leak.DO NOT USE if any damage is found.
- Only a professional or authorized repairman should repair this appliance.
- If the power supply cord is damaged, it must be replaced by the manufacturer, a certified service agent or asimilarly qualified person to avoid hazard and electrocution.
- If the unit has an abnormal sound or odor while in operation, please shut it down immediately and disconnect the power plug. Any repair must be done by a professional repairman.
- Please hold the water tank using two hands when adding water to avoid dropping the water tank.
- When the unit is on, DO NOT remove the water tank.
- DO NOT operate the unit when the water tank is empty.
- Do not add any chemical agents to the base or water tank. Do not add essential oils to the base or water tank.Only add essential oils to the specified essential oil tray as outlined in this manual. (See Fig. 3 Exploded Diagram)
- Before cleaning or moving the unit, turn off and disconnect the plug from its power source.
- When in operation, never place your hand inside the base or near the atomizer as it is dangerous and may cause electrocution.
- Do not add hot water above 104 °F to the water tank to avoid discoloration and distortion.
- Do not plug the unit into any type of power source with wet hands to avoid the risk of electric shock.
- Connect only the electrical plug to a secure wall socket.
- Ideal operating environment: Temperature: 41- 104°F, Humidity: <80% RH.
- IMPORTANT: Using tap water with a high mineral content aka “hard water” with any humidifier can cause fine white dust to be emitted. To avoid this, use distilled or demineralized water.
- Do not place any metals, chemicals, or detergents into the water tank or base; may cause poor atomization.
- Never pour out the remaining water from the base without unplugging and powering down the unit (power turned to OFF), otherwise, the atomizer will burn out immediately.
OPERATING ENVIRONMENT
- Place unit on a firm, flat and dry surface.
- Keep humidifiers away from children and infants.
- DO NOT use this appliance in any kind of inflammable environment.
- Keep the unit away from any heat source, i.e. heaters, furnaces, and avoid direct sunlight.
- Keep unit in normal room temperatures. Do not operate the unit in freezing temperatures.
- Direct nozzle to spray mist away from furniture and electric appliances, as they may become damp or be left with a white powder-like residue.
- Please follow the recommendations in the illustrations below to properly operate your humidifier in your home.
- Place the unit 6ft away from TVs, audio equipment, and any other, electronic appliances.
- Place the unit on a firm, steady, flat, and dry surface. Avoid any inclination.
- Place the unit away from any heat sources, such as furnaces, and avoid direct sunlight.
- Do not place the unit near curtains.
- IMPORTANT: Using tap water with a high mineral content aka “hard water” with any humidifier can cause fine white dust to be emitted. To avoid this, use distilled or demineralized water.
OPERATION
- Make sure the unit is unplugged and the knob is turned all the way to the left (counter-clockwise) and is set to the OFF position. You should be able to feel and hear a small click when the unit is turned from ON to OFF and from OFF to ON.
- With both hands, lift the water tank off base and flip it over to avoid water from dripping from the bottom of the tank. Optional: Decorative cover/nozzle is removable to gain access to the handle to lift the tank off the base with 1 hand. Note: Lifting the tank using the handle may cause some water to drip from the bottom of the tank, so using both hands to flip the tank upside down is recommended. If decorative cover/nozzle is removed, make sure to reattach them to the water tank prior to use.
- Twist open the valve.
- Fill with water.DO NOT add any other substance other than tap water or filtered water.
- Reattach the valve to the water tank and reposition the water tank onto the base with the water level window on the right side of the water tank. If using the handle to reposition the water tank onto the base, place another hand underneath the tank for support. NOTE: Allow about 10 seconds for the water to flow from the water tank into the base before you turn the unit on.
- Add essential oil to the sponge in the essential oil tray.Note this is an additional feature and not required to run the unit.
- A. With the knob in the OFF position, plug the unit into a wall socket. Rotate the knob clockwise and you should feel a click and the indicator light will turn green.B. Rotate the knob clockwise to increase the intensity of the mist.C. Press the LED button to turn on the LED night light located inside the water tank. The water level window on the right side of the unit should light up blue. Press the LED button again to turn off the LED light.D. The unit features an “Auto Shut Off” safety feature. When the unit is low on water, it will cut off the atomizer to stop the mist and the indicator light will turn red. To refill the water tank, turn the knob to the OFF position, unplug from the wall socket and repeat Steps 1-7.E. IMPORTANT TIP: DO NOT leave the humidifier plugged in for prolonged periods (i.e. several days or more) without use. This causes premature failure of the circuitry. When the humidifier is not in use, turn the knob to the OFF position and UNPLUG it.
TROUBLESHOOTING
IMPORTANT TIP: DO NOT leave the humidifier plugged in for prolonged periods (i.e. several days or more) without use. This causes premature failure of the circuitry. When the humidifier is not in use, turn the knob to the OFF position, then UNPLUG it.CONSEIL IMPORTANT: Ne laissez pas l’humidificateur branché pendant de longues périodes (c’est-à-dire plusieurs jours ou plus) sans utilisation. Cela provoque une défaillance prématurée des circuits. Lorsque l’humidificateur n’est pas utilisé, tournez le bouton en position d’arrêt et débranchez-le.
PROBLEM | PRI MARY CAUSE | SOLUTION |
Indicator light not illuminated with no mist. | The power supply cord is not properly plugged into the way socket.The power switch is not turned on. | Plug the power supply cord into a wall socket. Rotate knob clockwise to power on. |
The indicator light is red with no mist. | A. There is no water in the tank.
11.. The answer is dirty or floater is missing or stuck to the bottom EL Knob was not turned to off position during refills. D. Unit was turned on too quickly when the tank was attached to the base. L Unit reset needed. F. Too much moisture/humidity al circuit board. |
A. Add water to the tank.
S. Clean base. atomizer, and floater according to section 6 Maintenance. Check to make the site the floater is not stuck to the bottom. With the unit UNPLUGGED, add enough water directly to the base and make site the floater floats.C. Turn blob to the off position, that turn knob tom position.D. Turn knob to off position and wait 10 seconds before turning back on.E. Turn knob to off position Unplug unit from the vaU and wait 2 min. ; lug unit back into the wall, fill the water tank with water, and turn the knob to on position.F. Unplug unit from waU. The empty base of all water, dry with a towel, turn upside down, and let dry for 24 hours. |
The indicator light is green with little or no mist. | The atomizer is dirty. | Clean base and atomizer according to section 6 Maintenance. |
Mist has a bad odor. | The water, tank. or base is not clean. | Clean base and atomizer according to section 6 Maintenance. |
A humidifier is emitting white dust/residue. | Use of tap water with high mineral content, aka “hard water”. | Clean tank and base and use only demineralized or distilled water. |
SPECIFICATIONS
Model No. | EC-H2 |
Type | Ultrasonic Humidifier |
Power | 22 W |
Voltage | 120V/60Hz |
Capacity | 6.0 L |
Noise | <40 dB |
Mist Output | Lowest setting: 140ml/hr; Highest setting: 300ml/hr (+-20%) |
MAINTENANCE
IMPORTANT TIP: DO NOT leave the humidifier plugged in for prolonged periods (i.e. several days or more) without use. This causes premature failure of the circuitry. When the humidifier is not in use, turn the knob to the OFF position and UNPLUG it.
WARNING: Before performing any type of maintenance and cleaning, be sure to unplug the unit from its power source.
CLEAN THE WATER TANK (ONCE EVERY 2-3 WEEKS)Turn the unit OFF and lift the water tank from the base and rotate the valve counter-clockwise to unscrew it. Empty the water tank and wash tank and valve with mild dish detergent and warm water.
CLEAN BASE (ONCE A WEEK)Turn the unit OFF and unplug from the wall socket.WARNING: Use both hands to lift the entire base and tilt to one side to pour water out as shown in (Fig.7). Use mild dish soap and water to clean the base and clean away any residue near the floater and the atomizer with a brush or cotton swab as shown in (Fig.7). Only pour water into the base using a cap, never directly from a faucet. Never place the base under running water as this could cause water flow to reach the motor located at the bottom of the base.
Fig. 7TOP VIEW OF BASE
EXTERNAL CLEANING OF HUMIDIFIERRinse soft cloth in warm water below 104°F, add a small amount of mild dish soap too a soft cloth, and wipe off any surface stains.
HAVE AN ISSUE WITH YOUR ULTRASONIC HUMIDIFIER?
Enjoy hassle-free replacements: if your ultrasonic humidier is defective or damaged, we will ship you a new one ABSOLUTELY FREE. For fast and knowledgeable service, get in touch with one of our customer’s service experts right now! Email: [email protected] [email protected] Ultrasonic Humidifier To check out more of the products we offer visit: everlastingcomfort.net |
All parts have been tested by Intertek and are ETL Certified.
References
[xyz-ips snippet=”download-snippet”]