ClubSportShifter Carbon Knobs Kit
Quick Guide
CONTENTS
- 1x Carbon H-Pattern Shifter Knob
A - 1x Carbon Sequential Shifter Knob
B - 1x Quick Guide
SPECIFICATIONS
- Matte carbon gear knobs
- Added weight with metal cores
- H-Pattern knob: 220 g
- SQ knob: 141 g
- Meets the automotive standard (M12x1.5)
COMPATIBILITY
The Carbon Shifter Knobs are compatible with the following Fanatec shifters:
- ClubSport Shifter
- ClubSport Shifter V1.5
- ClubSport Shifter SQ
- ClubSport Shifter SQ V1.5
- ClubSport Shifter SQ V1.5 Limited Edition 2019
NOTE: Do not attempt mounting the shifter knobs onto third-party shifter shafts.
NOTE: Use a clean, moist cloth for cleaning the knobs. Only use water without any chemical additives.
NOTE: Do not overtighten the knobs. Tighten only by hand. Do not apply thread-locking fluid.
MOUNT & UNMOUNT
- To mount the selected Carbon Shifter Knob, carefully place the knob onto the shifter shaft and turn in a clockwise direction until firmly locked against the threading of the shifter shaft.
- To unmount the selected Carbon Shifter Knob, turn in a counterclockwise direction until the knob is completely free from the shaft threading.
 |
ENDOR products comply with t the E European U union Directive 2011/65/EU and its amendments, including exemptions for the use of lead such as high-temperature solder. ENDOR is working to phase out the use of these exempted substances where technically possible. |
 |
ENDOR AG hereby declares that all parts used in the manufacturing of Fanatec® products fully comply with the related requirements of the European Union regulation (EC) 1907/2006 concerning the Registration, Evaluation, Authorisation and Restriction of Chemicals (REACH). |
Manufactured by
Fanatec® is a registered trademark of Endor AG Designed and developed by Endor AG in Germany E.On Allee 3 – 84036 Landshut – GermanyTelephone: +49 (871) 9221-122 Fax: +49 (871) 9221-221Email: [email protected]Website: www.fanatec.com – www.endor.agMade in China
References
[xyz-ips snippet=”download-snippet”]