FEIT Electric T848_865 LEDG2 2 Linear LED Tube Light Instruction Manual

Table of Contents

FEIT Electric T848_865 LEDG2 2 Linear LED Tube Light

INSTALLATION GUIDE FOR TB TYPE A

This LED tube is intended to replace fluorescent tube lamps with ANSI designation 32W/48T8THIS PRODUCT MAY NOT BE COMPATIBLE WITH ALL BALLAST. FOR MORE INFORMATION ABOUT BALLAST COMPATIBLITY PLEASE VISIT WWW.FEIT.COMPLEASE REVIEW THE INSTRUCTIONS AND WARNINGS LISTED BELOW PRIOR TO PROPER INSTALLATION

CAUTION: RISK OF FIRE / ELECTRICAL SHOCK

LED Tube installation requires knowledge of luminaire electrical systems.
Risk of electric shock- disconnect power at source before installation.
Do not make or alter any open holes in an enclosure of wiring or electrical components during installation.
CAUTION RISK OF FIRE – IF THE LAMP OR LUMINAIRE EXHIBITS UNDESIRABLE OPERATION (BUZZING, FLICKERING, ETC.), IMMEDIATELY TURN OFF POWER, REMOVE LAMP FROM LUMINAIRE AND CONTACT MANUFACTURER.
Do not use with dimmers.
Do not look directly at the operating LED Tube.
Do not touch this product with wet hands.
Do not disassemble, repair or alter lamp
Designed for indoor applications only.
The luminaires shall be grounded.
Be careful not to touch the lamp pins to the metal housing when installing.
This device is not intended for use with emergency exits or not for emergency lighting.
DO NOT INSTALL THIS LAMP IN A PRE-HEAT LUMINAIRE.
THIS LAMP ONLY OPERATES ON ELECTRONIC BALLASTS. IF LAMP DOES NOT LIGHT WHEN THE LUMINAIRE IS ENERGIZED, REMOVE LAMP FROM LUMINAIRE AND CONTACT LAMP MANUFACTURER OR QUALIFIED ELECTRICIAN.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. CAN ICES-005 (B)