FETTEC OSD Board
Introduction
Thank you for purchasing the KISS compatible FETtec OSD Board.
Features
- Graphic OSD (STM32)
- Full KISS Tuning• Filter (PIDs, Rates, Settings)• LED control (RGB LED, Racewire)• VTX• Live data graphs (Voltage, motor rpm, current, motor temp, gyro values, link quality)• KISS GPS support + live map• Custom graphic pilot logo• Stick overlay• Custom layout
Connection via Solder pads or JST 6 pin plug (FETtec FC and KISS FC compatible) + video connection
- KISS FC compatible
The FETtec OSD works with KISS/FETtec FC firmware version 1.3RC45Y or later !
Connection Diagram
Layout
GND Reference Signal Ground5V from FCVin + Vout Video in and out n c not connected
JST-SH-1mm 6-pin connection
Dimension (in mm)
Basic Setup
6 Pin connection (cable included)(JST-SH-1mm 6-pin)
This can be connected via straight 6 pin adapter to any FETtec FC / KISS FC serial port
OSD only works with connected camera!
FETtec OSD Board to FETtec KISS FC
VTX connection
You can use this connection instead of connecting the VTX to the FC Smart audio always has to be connected to the FC
Camera connection
OSD Firmware
Please update the FETtec OSD Board before your first flight !
To update the FETtec OSD connect to FETtec Configurator and flash via FC passthrough latest firmware.
Settings
All settings are to set directly in the OSDTo get in the menu move the sticks in the shown direction at the start: Throttle 50%, then move Yaw left, Pitch up
Mode 1:Mode 2:
In the menu:
OSD settings:
Issues in the picture
- OSD SYNC AUTO SYNC
- in case of unsharp lines play with LEFT/WITH values try to avoid WITH values above 400
- make a PAL/NTSC layout reset
Choose LAYOUT SET POSITIONS in the SETTINGS.Now the elements are movable along the grid.Skip between the elements and select them to set new position.
To exit the ´move menu´ hold stick Yaw left for a few seconds
[xyz-ips snippet=”download-snippet”]