FlowerHouse Pumpkin Chair Instruction Manual

Table of Contents

FlowerHouse Pumpkin Chair

Open the package and unwrap the four short legs and put rubber feet on each of the four legs (if not already attached).
Connect the four legs to the X-frame on the lower bow of the Pumpkin Chair Stand using the 4 shorter nuts and bolts
Attach upper bow to lower bow to make C- frame, attach using 2 longest nuts and bolts.
Open Pumpkin Chair Frame completely and put the four smallest nuts and bolts in place.Make sure the flat tops are on the inside of the chair, so they do not poke through the fabric or through the seat
Take the center loop and slide through top flap opening.Proceed to close top and bottom flaps by connecting hooks to eyelets.
One at a time, slide the O-rings of the side straps over the center attachment strap.
Pull the center strap taut through the stacked O-rings.
Lift the chair and slide the attachment strap over the end cap into the securing tabs.Place flat cushion in chair, followed by large over-stuffed cushion.
Make sure all nuts and bolts are tightened throughout the stand and chair. Place in any level location and enjoy your Pumpkin Chair!