2~656GEP-35A-F4User Manual
SPECS:
| Model Name：GEP-35A-F4MCU: STM32F411IMU: MPU6000 gyro/accelerometer(SPI)Firmware target: GEPRCF411OSD: Betaflight OSD w/ AT7456EvCurrent: YESOSD: YESBeeper: YESLED: YESUSB: micro USB | BEC output: Intergrated LC FilterESC MCU: BB21F16GContinuous current: 35AMAX current: 45A (10s)Input: 2~6SSupports：Dshot600,Oneshot,MultishotCurrent meter: 210Traget: G_H_30Size: 32x32mm BoardInstalling Hole：26.5×26.5mm,M2Weight: 8.3g |
Inistruction Diagram
DJI Digital FPV System
Note: not all combinations are valid. When the flight controller firmware detects this the serial port configuration will be reset.Note: Do NOT disable MSP on the first serial port unless you know what you are doing. You may have to reflash and erase your configuration if you do.
Receiver
Note: not all combinations are valid. When the flight controller firmware detects this the serial port configuration will be reset.Note: Do NOT disable MSP on the first serial port unless you know what you are doing. You may have to reflash and erase your configuration if you do.
FRSKY R-XSR
TBS Crossfire Nano RX
DSM/DSMX
FlySky FSA8S V2
Note: not all combinations are valid. When the flight controller firmware detects this the serial port configuration will be reset.Note: Do NOT disable MSP on the first serial port unless you know what you are doing. You may have to reflash and erase your configuration if you do.
F.Port
set serialnc_halfduplex = ON save
VTX
Note: not all combinations are valid. When the flight controller firmware detects this the serial port configuration will be reset.Note: Do NOT disable MSP on the first serial port unless you know what you are doing. You may have to reflash and erase your configuration if you do.
Note: not all combinations are valid. When the flight controller firmware detects this the serial port configuration will be reset.Note: Do NOT disable MSP on the first serial port unless you know what you are doing. You may have to reflash and erase your configuration if you do.
Camera
LED & Buzzer
GPS
Note: not all combinations are valid. When the flight controller firmware detects this the serial port configuration will be reset.Note: Do NOT disable MSP on the first serial port unless you know what you are doing. You may have to reflash and erase your configuration if you do.
Note: Because the flight control UART port is limited, the GPS can only be connected when the UART1 is free, otherwise the GPS will not work properly!
| Official website |  http://www.geprc.com |
| Manual | http://geprc.com/support |
| https://www.facebook.com/geprc/ |
|
| https://www.instagram.com/geprc/ |
[xyz-ips snippet=”download-snippet”]