GHOST CONTROLS AXWK Premium Wireless Keyboard Instructions

GHOST CONTROLS AXWK Premium Wireless Keyboard

BEFORE YOU BEGIN

  1. Keypad housing must be removed and two (2) C batteries (not included) need to be installed before programming. Installing the batteries requires you to unscrew the bottom two screws and to insert the batteries.
  2. You must create a Master PIN for your Ghost Controls keypad before any other programming functions can be performed. The keypad will store only one master pin and can store an additional 19 access pins. The master pin must be used to enable additional features.The keypad will remain in programming mode for up to 1 minute between button presses to allow adequate time to go through each step. If you enter an invalid sequence, the keypad will immediately drop out of programming mode and you will have to start back at Step 1 of the programming sequence.

STEP 1. PROGRAMMING YOUR MASTER PIN

  1. Press and release the Program Button
  2. Enter 0000
  3. Press and release the Program Button
  4. Enter 76
  5. Press and release the Program Button
  6. Enter your 4 digit master pin (cannot use 0000)
  7. Press and release the Program Button

STEP 2. TEACHING YOUR REMOTE TO THE KEYPAD

  1. Press and release the Program Button
  2. Enter your 4 digit master pin
  3. Press and release the Program Button
  4. Enter 58
  5. Press and release the Program Button.
  6. Press the bottom edge of the remote transmitter against the keypad below the send button as shown (needs to touch keypad)
  7. PRESS & HOLD THE BUTTON ON THE REMOTE until you hear 3 beeps, and then 2 beeps from the keypad.

lineup remote with LEARN button facing keypad. Then touch remote to keypad as shown under the send button and press and hold the to learn the remotes code

STEP 3. MOUNT KEYPADKeypad can be mounted no further then 60′ and has to be within site from the gate.

PROGRAMMING ADDITIONAL GATE ACCESS PINS

ACTIVATE/DEACTIVATE SPECIAL FEATURES (CAN ONLY USE WITH MASTER PIN)

RESTORING YOUR KEYPAD BACK TO FACTORY DEFAULT

  1. Remove one of the “C” batteries from the back of the keypad for 15 seconds
  2. Reinstall the “C” battery and immediately press and release the program button 3 times
  3. If successful, keypad will beep 3 long beeps followed by 2 short beeps
  4. If unsuccessful, repeat the above steps

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov

www.GhostControls.com

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,