GEP Naked GoPro Hero 8 User Manual
Overview
GoPro hero 8 naked, specially designed by GEP team for quadcutter, finally meets you..The newly designed BEC is perfect for GoPro 8. Support 2-6s voltage input and output . It is equipped with POWER/MODE and REC button, and has a quick detachable GH1.25-3P connector to support remote control..
Feature
- It’s specially designed for quadcutter, and its ultra light weight is only 25.7g
- The 4K ultra wide angle camera has a large field of vision
- ,, Recording
- Scan preinstall QR code switch settings
- BEC board input volage 2S-6S, output 5V-2A
- Integrated GoPro POWER/MODE button and REC button, operation quickly and conveniently.
- GH1.25-3P connector is used to connect flight control and realize remote control
- Mounting seat, which is convenient and fast to install
- UV protection lens to protect the camera
- Nd16 filter to reduce the light input of camera sensor
Specification
- Model：GEP GoPro Hero 8 Naked
- Size：60*40*22.5mm
- Weight：25.7g
- Input voltage：2-6S
- Output：
- Memory：SD card
- Connector：GH 1.25 3P
Indicator status
Connect GH1.25 Control cable with camera and input 2-6s power. LED will flash 1 times,BEC plate power light is always on（green light）.
GEP GoPro Hero 8 Naked Manual
GEP GoPro Hero 8 Naked BEC Board Diagram
GoPro Hero 8 Naked Set Guide
Recording with remote control
- Weld control cable to FC
- Red wire→FC positive pole
- Black wire→FC negative pole
- Yellow wire→FC LED
- Connect FC to BETAFLIGHT ground workstation, enter the following command on the command wire, save.resource LED_STRIP 1 NONEresource PINIO 1 A08set pinio_box = 40,255,255,255Save
- Turn on the USER1 mode under the mode option, add range to Transmitter idle switch.
- Turn the BEC power switch to left, connect the control cable.
- Supply power to FC,GoPro8 Naked will auto start.Operation remote control AUX4 switch, move the cursor from the white area to the yellow area and back to the white area to start the recording.Repeat the operation again to end the recoding.Notes: GEPRC-F722-AIO and F411-AIO have the same wiring but different codes, as follows:resource LED_STRIP 1 NONEresource PINIO 1 A01set pinio_box = 40,255,255,255Save
Notes: GEPRC-F722-AIO and F411-AIO have the same wiring but different codes, as follows:resource LED_STRIP 1 NONEresource PINIO 1 A01set pinio_box = 40,255,255,255SaveAppendix
GEPRC Technology Taobao Store: https://geprc.taobao.com/GEPRC Technology Official Website: https://geprc.com/GEPRC Technology Official QQ Group:499699918
References
[xyz-ips snippet=”download-snippet”]