0018633600186337Radio-Controlled DCF Wall Clock“PG-300”

Operating Instructions

Operating instruction

Thank you for choosing aHama product.Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of Warning Symbols and Notes

WarningThis symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.NoteThis symbol is used to indicate additional information or important notes.

Package Contents

  • PG-300 DCF wireless wall clock
  • 1(AA) battery
  • These operating instructions

Safety Notes

  • Protect the product from dirt, moisture, and overheating, and only use it in an adry environment.
  • Do not use the product in areas where the use of electronic devices is not permitted.
  • Do not drop the product and do not expose it to any major shocks.
  • Do not put the product near interference fields, metal frames, computers, TVs, etc. Electronic devices and window frames can negatively affect the functionality of the product.
  • Do not modify the product in any way. Doing so voids the warranty.
  • Keep the packaging material out of the reach of children due to the risk of suffocation.
  • Dispose of packaging material immediately according to locally applicable regulations.
  • The product is intended for private, non-commercial use only.
  • Use the product for its intended purpose only.
  • Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
  • Do not operate the product outside the power limits given in the specifications.
  • Do not open the device or continue to operate it if it becomes damaged.
  • Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
  • Keep this product, like all electrical products, out of the reach of children!
  • Use the item only in moderate climatic conditions.

Warning –Batteries

  • When inserting batteries, note the correct polarity (+ and markings) and insert the batteries accordingly. Failuretodosocould result in the batteries leaking or exploding.
  • Only use batteries (or rechargeable batteries) that match the specified type.
  • Before you insert the batteries, clean the battery contacts and the polar contacts.
  • Do not allow children to change batteries without supervision.
  • Do not mix old and new batteries or batteries of a different type or make.
  • Remove the batteries from products that are not being used for an extended period (unless these are being kept ready for anemergency).
  • Do not short-circuit batteries.
  • Do not charge batteries.
  • Do not throw batteries in a fire.
  • Keep batteries out of the reach of children.
  • Never open, damage, or swallow batteries or allow them to enter the environment. They can contain toxic, environmentally harmful heavy metals.
  • Immediately remove and dispose of dead batteries from the product.
  • Avoid storing, charging, or using the device in extreme temperatures and extremely low atmospheric pressure(for example, at high altitudes).

Getting Started

4.1 Inserting the battery

  • Remove the battery that was already inserted into the clock, remove the protective film if necessary as well as the contact interrupter and re-insert the battery with the correct polarity. The clock is ready for operation.

4.2 Replacing the battery

  • Remove and dispose of any used batteries. Insert the new battery (AA). Ensure that the polarity of the battery corresponds to the symbols in the battery compartment.

Installation

You can mount the wall clock on a wall using the opening on the back.Warning –Mounting Note:

  • Before mounting the clock, ensure that the chosen wall is suitable for the weight to be mounted, and make sure that there are no electrical wires, water, gas, or other lines at the installation site on the wall.
  • Purchase special fastening materials from specialized dealers.
  • Do not mount the product above locations where persons might linger.

Operation

6.1 Automatic time setting

  • Once the battery is inserted properly, the clock will automatically be set to 12:00 and its reception will be activated. As soon as the DCF signal was received and processed (approx. 3minutes up to a maximum of 15 minutes), the correct time is displayed automatically.Do not move the clock during this process.
  • If the clock has not correctly set itself after 15 minutes, there is a problem with the reception or with the selected location.
  • Repeat the setting process at another location. To do this, remove the battery for approximately 1minute and then reinsert it into the battery compartment.

6.2 Setting the time manuallyM.SET button:

  • Hold down the M.SET button until the appropriate time appears.
  • As soon as the clock receives the DCF signal, it will reset the time. REC button:
  • Press and hold the REC button on the rear side for 3seconds. The secondhand moves to the 12 positions. It then tries to receive the time signal and reset itself accordingly.
  • If the clock finds an aDCF signal, it adjusts itself automatically. If no signal is received within 16 minutes, the clock reverts to the original time.

RESET button:

  • Press and hold the RESET button on the rear side for 3seconds.The clock sets itself to position 12. It then tries to receive the time signal and reset itself accordingly.

NoteNote that electronic devices such as TVs, PCs, etc. can interfere with reception when located within up to two metres of the product.

Care and Maintenance

Only clean this product with a slightly moist, lint-free cloth, and do not use aggressive cleaning agents. Make sure that water does not get into the product.

Warranty Disclaimer

Hama GmbH &CoKGassumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/ or safety notes.

Technical Data

DCF wireless wall clock

Power supply 1.5 V1xAAbattery (alkaline)

Recycling Information

Note on environmental protection:After the implementation of the European Directive 2012/19/ EU and 2006/66/EU in the national legal system, thethe following applies: Electric and electronic devices, as well as batteries, must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of utilising old devices/Batteries, you are making an important contribution to protecting our environment.

Declaration of Conformity

Hereby, Hama GmbH &CoKGdeclares that the radio equipment type [00186336, 00186337] is in compliancewith Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.hama.com ->00186336, 00186337 -> Downloads.

Frequency band(s) 77.5 kHz

Hama GmbH &CoKG86652 Monheim /GermanyService &Supportwww.hama.com+49 9091 502-0

All listed brands are trademarks of the corresponding companies.Errors and omissions excepted, and subject to technical changes.Our general terms of delivery and payment are applied.00186336_00186337/07.21

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, , ,