hama 00123159 Radio-Controlled DCF Wall Clock Instruction Manual

00123159186344Radio-Controlled DCF Wall Clock DCF-Funk-Wanduhr“PG-300”Operating instruction

Controls and Displays

1. SET button
2. RESET button
3. WAVE button
4. Battery compartment
5. Thermometer display (°C on outer scale/°F on the inner scale)
6. Hygrometer display

Explanation of Warning Symbols and Notes

WarningThis symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.NoteThis symbol is used to indicate additional information or important notes.

Package Contents

• Radio Controlled DCF Wall Clock
• 1 AA battery
• These operating instructions

Safety Notes

• Protect the product from dirt, moisture, and overheating, and only use it in an adry environment.
• Do not use the product in areas where the use of electronic devices is not permitted.
• Do not drop the product and do not expose it to any major shocks.
• Do not put the product near interference fields, metal frames, computers, TVs, etc. Electronic devices and window frames can negatively affect the functionality of the product.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep the packaging material out of the reach of children due to the risk of suffocation.
• Dispose of packaging material immediately according to locally applicable regulations.
• The product is intended for private, non-commercial use only.
• Use the product for its intended purpose only.
• Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
• Do not operate the product outside the power limits given in the specifications.
• Do not open the device or continue to operate it if it becomes damaged.
• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
• Keep this product, like all electrical products, out of the reach of children!
• Use the item only in moderate climatic conditions.

Warning –Batteries

• When inserting batteries, note the correct polarity (+ and -markings) and insert the batteries accordingly. Failure to do so could result in the batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that match the specified type.
• Before you insert the batteries, clean the battery contacts and the polar contacts.
• Do not allow children to change batteries without supervision.
• Do not mix old and new batteries or batteries of a different type or make.
• Remove the batteries from products that are not being used for an extended period (unless these are being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a fire.
• Keep batteries out of the reach of children.
• Never open, damage, or swallow batteries or allow them to enter the environment.They can contain toxic, environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries from the product.
• Avoid storing, charging, or using the device in extreme temperatures and extremely low atmospheric pressure(for example, at high altitudes).

Getting Started

4.1 Inserting the batteryRemove the battery that was already inserted into the clock, remove the protective film if necessary as well as the contact interrupter, and then re-insert the battery with the correct polarity. The clock is ready for operation.4.2. Replacing the battery

• Remove and dispose of any used batteries. Insert the new battery (AA).
• Ensure that the polarity of the battery corresponds to the symbols in the battery compartment.

Installation

You can mount the wall clock on a wall using the opening on the back.Warning ­ Mounting Note:

• Before mounting the clock, ensure that the chosen wall is suitable for the weight to be mounted, and make sure that there are no electrical wires, water, gas, or other lines at the installation site on the wall.
• Purchase special fastening materials from specialized dealers.
• Do not mount the product above locations where people might be.

Operation

Once the battery is inserted properly, the clock will automatically be set to 12:00 pm and its reception will be activated. As soon as the DCF signal was received and processed (approx. 3 minutes up to a maximum of 15 minutes), the correct time is displayed automatically.

• Do not move the clock during this process.
• If the clock has not correctly set itself after 15 minutes, there is a problem with the reception or with the selected location.
• Repeat the setting process at another location. To do this, remove the battery for approximately 1 minute and then reinsert it into the battery compartment. After you have changed the location of the device, use a pointed object (e.g. a pen) to press and hold the WAVE button for about 2 seconds. The clock automatically sets itself to the 12 o’clock position and is once again ready to receive the DCF signal.

NoteNote that electronic devices such as TVs, PCs, etc. can interfere with reception when located within up to two meters of the product.6.1. Manual settingIf a DCF signal can definitely not be received at the installation location, set the time manually.

• To set the time manually, use a pointed object (e.g. a pen) to press and hold the SET button.
• The clock will continue to advance as long as the SET button is held. · If you press the RESET button, the clock automatically moves to the 12 o’clock position, even if you do not hold the button.

Care and Maintenance

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents. Make sure that water does not get into the product.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product, or from failure to observe the operating instructions and/or safety notes.

Technical Data

Radio Controlled DCF Wall Clock

Recycling Information

Note on environmental protection:After the implementation of the European Directive 2012/19/EU and 2006/66/ EU in the national legal system, the following applies: Electric and electronic devices, as well as batteries, must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual, or the package indicates that a product is subject to these regulations. By recycling, reusing the materials, or other forms of utilizing old devices/Batteries, you are making an important contribution to protecting our environment.

Declaration of Conformity

Hereby, Hama GmbH & Co KG declares that the radio equipment type [ 00123159, 00186344] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.hama.com -> 00123159, 00186344 -> Downloads.

Hama GmbH &CoKG86652 Monheim /GermanyService &Supportwww.hama.com+49 9091 502-0All listed brands are trademarks of the corresponding companies.Errors and omissions excepted, and subject to technical changes.Our general terms of delivery and payment are applied.00123159_00186344/07.21

References

• 
  hama.com