HamiltonBuhl VENU100W Water-Resistant (IP54) Portable Amplifier System Instruction Manual

Table of Contents

Instruction Manual

VENU100WWater-Resistant (IP54) Portable Amplifier System

80 Little Falls Road, Fairfield, NJ 070041-800-631-0868www.HamiltonBuhl.com

Introduction and Product Specifications

Introduction

Thank you for choosing the HamiltonBuhl VENU100W IP54 All Weather PortableAmplifier System. Please read this manual carefully before using it and retain for future reference. Please recharge this unit every month to achieve the best performance.

1.2 Product Specifications

Power Output	RMS 75W
Speakers	One 10″ Woofer Speaker; One 1″ Tweeter
Amplifier	class D
Power supply	AC: 120VAC/60Hz
DC: 2 x 12V 7A lead-Acid Batteries
Charging time	8-11 Hours
Operation time	5-7 Hours
Frequency response	50Hz-18KHz±3dB
Dimensions	20.3×14.6×13.5 inches
Weight	37.5 lbs.

Important Safety Information

When a failure or problem occurs, please contact the manufacturer for further troubleshooting, evaluation, and/or repair. One receiver cannot receive a signal from two of the same frequency microphones simultaneously. Other brand microphones with different frequencies cannot be used with this receiver.

Do not open or attempt to fix or adjust this product yourself. To reduce the risk of fire or electric shock, do not remove the cover. High voltage parts are inside.	Do Not Disassemble
To reduce the risk of electric shock, do not touch the power outlet during thunderstorms. Do not touch the power plug with wet hands. Do not put liquid containers or small metal parts on the top of the equipment. Do not drop metal parts or flammables into the equipment.	Do Not Touch
To reduce the risk of fire or electric shock from a damaged power cord, do not pull hard when pulling out the power plug. Always grasp the plug tightly, then pull it out gently. Turn off the power if this equipment will not be used for a long period of time.	Pull Out AC Plug
To reduce the risk of electric shock, use the specified power voltage only. Do not expose this equipment or power cord to the sun, moist or dusty places. Keep away	Caution
To prevent damage, never put heavy items on top of this equipment. Place and use on flat, stable surfaces only.
Always insert the power plug fully into a power outlet. Please pull out the power plug and contact the manufacturer if the following occurs. Smoke comes out of the unit or you smell burning. Unit is dropped on the ground and damaged. The power cord is damaged. (If the core is exposed or cord is frayed)	Warning

Parts Description

Main Unit

Handle
Telescopic Trolley
Metal Shield
Battery Compartment
Wheels
Pole Mount
Control Panel
Cabinet

Control Panel

AC Power input
Power Switch
Voice Priority Switch
Battery Status
MIC Volume Control
Wireless MIC CH-A RF LED indicator
Wireless MIC CH-B RF LED indicator
TONE Control
ECHO Control
AUX / MP3 Volume control
BASS Control
TREBLE Control
MASTER Volume Control
RCA AUX In
USB Port
Audio Module Displayer
MP3 Power: ON / OFF
Repeat: LCD displayed “PONE” indicate repeat one file,” PALL” indicated repeat all
Mode: Select between USB I Bluetooth mode.
CH-: Previous file
CH+ : Next file
EQ : Select EQ 00—NORMAL/ 01—POP / 02—ROCK / 03—JAZZ/ 04—CLASSIC / 05—COUNTRY.
Previous File
Next File
Pause / Play
VOL-: Volume Down
VOL + : Volume Up
Number Keys: To fast select two digit files. Press 0 then press desire two digits.For example to fast select file #65. Press 0 and 6 and 5.

Main — Operations Guide

Quick Start

Set the POWER switch (2) to ON.The battery charge is indicated by the LEO indicator (4). Please charge the unit if the level is LOW.The unit will switch off automatically when the battery runs low.Insert the power cord into the DC input jack (1) to charge the unit.

Turn on the microphone power switch. The RF LED (6) or (7) on the control panel will light. This means that the receiver is receiving the signal and is in normal working condition.
To use an external sound source, insert a signal cable into the AUX / MP3 input (14). Adjust the volume via the LINE! MP3 volume control (10).
The unit has TONE control (8), ECHO control (9) for a microphone effect, BASS (11), and TREBLE (12) controls.
Set the overall volume via the MASTER control (13).
Voice Priority: Set the switch (3) to on. If you speak into the microphone, the music will be cut off and resume once the microphone is not used anymore.

Charging The Unit

Prior to using this system for the first time, please insert the AC lead into the AC socket of the player and plug the other end into a suitable wall outlet. Charging time is approx. 8-11 hours.
Please recharge once every 3 months if you don’t use the unit for a long period of time.NOTE: Please turn the power off when you are not using the

Operation

Bluetooth connection: Turn on the Bluetooth function on your mobile device. Search, select, and pair with “PA SYSTEM” for Bluetooth connection.
Selecting an audio file: Press the number keys on the remote control to select the desired If the number has two digits, press 0 first and then enter the other two digits. Example: 58 = 0+5+8.

NOTE: If ever dispose of this unit, please take it to a recycling center in your area.

Wireless Transmitter

Wireless Handheld Microphone (UHF 3V) Parts Description

Open battery cover (6) and insert batteries (insert carefully paying attention to positive and negative poles). Close the battery cover.
Turn on the microphone power switch (4) and the power LED indicator (2) will flash on once then When indicator (2) stays red, it indicates battery power is low. Please change the battery.
When switching on microphone power, please operate the switch step-by-step. When the switch moves to the center, please wait for at least 0.2 seconds or it may cause noise. Then only – move to on position.

Microphone Type	Dynamic Handheld
Frequency	902MHz-928MHz
Spurious Emissions	>55dBm
Power Source	2 x “AK 1.5V Batteries (included)
Operating Time	Approx. >6 Hours
On-board Indicators	Power Status/On/Off Switch
Dimensions	0 2′, L-10.2″
Weight	0.36 lbs.

Optional Wireless Body Pack Transmitter

Optional Wireless Body Pack Transmitter (UHF 3V) Parts Description

Open the battery cover (6) and insert 2 x *AA” batteries according to the polarity indicate( with + or -.
Turn ON POWER switch (1). The POWER LED indicator (2) will turn green, indicating good battery voltage.
Plugin headset microphone into MIC IN (1).

Optional Wireless Body Pack Transmitter Specifications

Frequency	UHF 902MHz-928MHz
Spurious Emissions	>55dBm
Power Source	2 x ‘AA” 1.5V batteries (included)
Operating Time	5-7 Hours
On-board Indicators	Power Status/On/Off Switch
Dimensions	2.7″x 1.0N4.3″
Weight	0.22 lbs.

Headset Microphone Specifications

Microphone Type	Condenser
Frequency Range	50Hz-16KHz
Directional Characteristic	Uni-Directional
Sensitivity	-46dB±3dB (1V / PA @1KHz)
Output Connector Cable	φ0.14″CLR
Material	Black Shield Cover
Dimensions	0.0r x40″
Weight	0.16 lbs

Remote Control Battery

Battery InstallationFirst, open the battery cover and remove the protective PVC plastic film from the contacts before using the remote control.

Changing the Battery

Battery life is approximately one year, depending on usage frequency and operation. If the remote control does not work when it is near the unit, please change the battery.

Remote Control Range of Operation

Remotecontroloperationrange: Within 12 feet from the front panel -.45°.
Effective distance of remote control may be different according to differences in the

Valve Regulated Sealed Lead Acid Battery

Please follow these instructions to use and maintain the battery:When the battery is fully depleted, charge it fully within 72 hours, to avoid battery damage. Charging the battery in a timely manner will help prevent an internal short circuit, outer case distortion, plate corruption, or a voltage drop.

Sealed lead acid battery features:A. The battery can be charged at any time.B. Battery efficiency can be affected by environmental factors (temperature, humidity). (The optimal temperature is 68 – 78 F.)C. To avoid a dead battery, charge once a month when not in use.D. The normal lifespan of a battery is one year.
IMPORTANT NOTE:A. Be sure to charge for 24 hours the first time charging.B. Recharge the battery once per month when not in use.C. Charge the battery fully before each use.

Basic Set

1	Main Unit	1 pc.
2	AC Cord	1 pc.
3	Wireless Handheld Microphones	2 pcs.
4	1.5V AA Battery	4 pcs.
5	Instruction Manual	1 pc.
6	Remote control	1 pc.
7	USB cover	1 pc.

Product Registration:

Visit www.HamiltonBuhl.com

Click on Customer Care
Click on Product Registration Icon
Please fill out all fields marked with to register

Warranty:

report this ad

Warranty begins the date the item ships from our warehouse.All products have a one-year warranty from the original date of shipment unless otherwise noted.