Homedics MIR-150 Compact Charging LED Mirror Instruction Manual and Warranty Information

COMPACT CHARGING LED MIRROR

INSTRUCTION MANUAL AND WARRANTY INFORMATIONONE YEAR LIMITED WARRANTY

MIR-150

READ ALL INSTRUCTIONS BEFORE USE.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

IMPORTANT SAFEGUARDS:

WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:

  • Not for use by children.
  • Keep dry – DO NOT operate in wet or mosit conditions.
  • Use this appliance for the intended use as described in this booklet. DO NOT use attachments not recommended by HoMedics.
  • NEVER operate the appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return it to the HoMedics Service Center for examination and repair.
  • Keep cord away from heated surfaces.
  • NEVER drop or insert any object into any opening.
  • DO NOT operate under a blanket or pillow. Excessive heating may occur and may cause fire or injury to persons.
  • DO NOT carry this appliance by the cord or use cord as a handle.
  • This appliance is for household and indoor use only.
  • DO NOT attempt to repair the appliance. There are no user serviceable parts. For service, send to a HoMedics Service Center. All servicing of this appliance must be performed by authorized HoMedics service personnel.
  • Do not place or store appliance where it can fall or be pulled into a bath or sink. Do not place in or drop into water or other liquid.
  • Recycle or dispose of battery properly in accordance with all local, state, province, and country regulations.

SAFETY CAUTIONS:

PLEASE READ THIS SECTION CAREFULLY BEFORE USING THE APPLIANCE.

  • Ensure that your hands are dry when operating the controls or removing the plug.
  • Do not look directly into the LED light.
  • Do not damage, destroy, modify, forcefully bend, pull or twist the cable. Do not place or clamp heavy objects on the charging cable.
  • Turn off the appliance and unplug it from the power source when it is fully charged.
  • Avoid placing the mirror near sharp objects to prevent any damage and scratches to the surface.
  • Before using the power bank function, check the rated current of the mobile device. If the rated current is less than 45mA, it is not recommended to use the LED mirror to charge it (ie, Bluetooth headset, smartwatches, fitness bands, etc).

UNIQUE FEATURES & SPECIFICATIONS

PHONE CHARGING PORT

Phone charging cable not included

1X AND 5X MAGNIFICATION

Choose from Standard and Close-up views

8 LED LIGHTS

Surrounds Mirror for even illumination

RECHARGEABLE

Mirror charging cable Included

HOW TO USE

BEFORE TURNING THE UNIT ON

  • Make sure the unit is fully charged

CHARGING THE BATTERY

Before turning the unit on, connect the unit to a power source or AC adapter by connecting the charging cable to the charging port located on the side of the unit. A Blue LED indicator will blink intermittently, indicating that charging is taking place. When charging is complete, the LED indicator will stop blinking and remain steady. It takes approximately 5 hours for a full charge, which will provide up to 10 hours of use, if only using the LED light. When the battery is getting low, the blue LED indicator will blink and then turn off, indicating that the unit needs to be recharged.

USING THE MIRROR

  • Open the compact to expose the mirror and LED light.
  • Press and hold the Power ON/OFF button for 3-seconds to turn the LED lights on.
  • Press and hold the Power ON/OFF button again for 3-seconds, or quickly press twice to turn the LED lights OFF.
  • Close the mirror by pressing shut until it locks into position with a click.

USING THE POWER BANK

  • Connect the device to the power bank using your phone’s charging cable to the USB Phone Charging port located on the side of the mirror.
  • When charging electronic devices, the blue LED charging indicator will illuminate and stay lit.
  • When the power is getting low, the blue LED will blink and turn off, indicating that the unit needs to be recharged.

NOTE: Always disconnect the charging cable after you finish using the power bank function.

CLEANING AND CARE

CAUTION: before cleaning the unit, turn power off and remove from the charging base.

TO CLEAN THE SURFACE

Clean the surfaces of the unit as needed with a dry, soft cloth.

NOTE: Never use water, alcohol or abrasive cleansers to clean the surface of the unit. Doing so will result in malfunction or discoloration of the unit.

TO STORE

Store in a safe, dry place, out of reach of children.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE SOLUTION
Unit will not operate
  • Unit is not charged
  • Charge the unit by connecting it to the charging cord and plugging it into a USB power source.
  • Press and hold the POWER ON/OFF button for 3-seconds to turn the power on.
  • Check circuits, fuses, try a different outlet or USB power source.
The LED light is not bright enough
  • Unit is not fully charged
  • Fully charge the unit by connecting it to the charging cord and plugging it into a USB power source.
FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receive is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This class B digital device complies with Canadian ICES-003.

Homedics MIR-150 Compact Charging LED Mirror Instruction Manual and Warranty Information – Homedics MIR-150 Compact Charging LED Mirror Instruction Manual and Warranty Information –

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,