HOMETECH Fireplace Insert Log Heater With Remote Owner’s Manual

HOMETECHFireplace Insert Log Heater With RemoteOwner’s Manual

MODEL : FP201R

WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.

PET OWNERS WARNING:

The health of some small pets including birds are extremely sensitive to the fumes produced during the first-time use of many appliances. These fumes are not harmful to humans but we recommended that you do not use your heater around birds and small pets during its initial use until the manufacturing corrosion coatings burn off.

Technical support: 1-866-206-0888Service email:

Thank you for choosing our Electric Fireplace, This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product.Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater,

IMPORTANT INSTRUCTIONS

When using this electric unit, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury. Please review the following:

  1. Read ALL instructions before using this unit.
  2. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself.
  3. This heater may get hot when in use To avoid burns, DO NOT let bare skin touch hot surfaces.
  4. Keep combustible materials, such as furniture, pillows, bedding, paper, clothes, andcurtains at least 3 ft from the front of the heater and keep them away from the sides, topT and rear. DO NOT place towels or other objects on the heater.
  5. Extreme caution is necessary when any heater is used by or near children or the disabled, or when the heater is left operating and unattended.
  6. DO NOT operate any heater with a damaged cord or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
  7. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. NEVER locate heater where it may fall into a bathtub or other water container.To protect against electrical hazards, DO NOT immerse in water or other liquids.
  8. DO NOT touch the control panel or plug with a wet hand
  9. DO NOT run cord under carpeting. DO NOT cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
  10. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
  11.  To prevent a possible fire, DO NOT block the air intakes or exhaust in any manner. DO NOT use on soft surfaces, like a bed, where openings may become blocked.
  12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline, paint, explosive and/or flammable liquids are used or stored. Keep unit away from heated surfaces and open flames.
  13. Always plug heaters directly into a wall outlet / receptacle Never use with an extension cord or relocatable power tap (outlet/power strip)
  14. To avoid fire or shock hazard, plug the unit directly into a 120 V AC electrical outlet.
  15.  To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on the plug, DO NOT unplug by pulling on the cord.
  16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
  17. Use only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments that are not recommended or sold by unauthorized dealers may cause hazards.
  18. Always use on a dry, level surface. Use on floor only.
  19. DO NOT use outdoors.
  20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any solid-state speed control device,
  21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit.
  22. Doing so will void your warranty. The inside of the unit contains no user serviceable parts.
  23. Qualified personnel shouid perform all servicing only.
  24. This appliance has a polarized plug (one blade is wider than the other). This plug is intended to fit a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, consult a qualified electrician. Do not connect the heater to extension cords, surge protectors, timers, direct breakers, or an outlet with other  appliances connected to the same outlet Risk of fire, overheat, malfunction, property damage, injury, or even death may result if not adhered to!
  25. This heater must be plugged into a 120V, 15 amp (or more) circuit of its own. Nothing else can be plugged into the same circuit If unsure if you home meets this specification, consult a certified electrician prior to use. Risk of fire, overheat, maifunction, property damage, injury, or even death may result if not adhered to!
  26. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction regarding use of the appliance by a personresponsible for their safety. Children should be supervised to ensure that they do not play  with the appliance.

SAVE THESE INSTRUCTIONS

SPECIFICATIONS

SAFETY FEATURES

Overheat Safety Feature

This heater is equipped with a overheat safety feature. When the heater’s internal components reach a certain temperature that could cause overheat or possible fire, the heater will automatically shut off.

WARNING: It is norma! for the power cord to fee! warm to the touch; however, a loose fit between the outlet and the plug may cause overheating of the plug If this occurs, try inserting the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for damage.

IN THE BOX

  • Electrical fireplace stove with heater
  • Remote control (with batteries)
  • Instruction manual

PRODUCT DIAGRAM

CONTROL PANEL

REMOTE CONTROL

PREPARATION

Place the heater on a firrrv level surface and plug into a 120V 60Hz power outlet. Caution: The rear of the heater should be at least 4 inch away from the wall Please pull the insulating film out of battery cover before using the remote control.

OPERATING INSTRUCTIONS

1. First turn on the Power switch on the right side of the heater. The Power switch supplies power to all the function of the fireplace. This switch must be in T position for any functions including the remote contra I to work.

2. Setting timer-power-offCaution! ONLY under power-on mode can you set timer-power-off function.

3. Setting timer-power-onCaution! ONLY under standby mode can you set timer-power-on function.

4. Setting heatUnder standby mode, press Heater button to start heater.

5. Setting flameUnder standby mode, press the Flame button to watch the flame effect.

MAINTENANCE

  1. Turn off the heater with the power switch,
  2. Unplug the unit and let it cool completely,
  3.  The outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary, After cleaning, dry the unit with a soft cloth, CAUTION: DO NOT let liquid enter the heater.
  4. DO NOT use aicohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface.
  5. DO NOT immerse the heater in water.
  6.  Wait until the unit is completely dry before use.
  7.  If the unit will not be in use for a long period of time, please take the battery out of the remote control using the following steps.

STORAGE

Store the heater in a cool, dry location when not in use To prevent dust and dirt build-up, use the original packaging to repack the unit.

TROUBLE SHOOTING

If the heater will not operate, please check the following before seeking repair advice:

  1. Check if the power cord is plugged into an electrical outlet, if not, plug it in
  2. Check if electricity to the main power switch (in the back) is working.
  3. Check that the power switch is on

WARRANTY INFORMATION

This product carries a one (1) year warranty against defects in workmanship and materials Hometech agrees to replace a defective product, within the stated warranty period, when returned to the place of purchase with proof of purchase. This product is not guaranteed against wear or breakage due to misuse and/or abuse.

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,