Honeywell T3R Programmable Thermostat Relay Pairing Instructions

WIRELESS BINDING GUIDET3R Programmable Thermostat

On the Wireless Relay Box

  1. Press the pinhole button for 3 sec. The LED should flash ORANGE once.
  2. Press and hold the buttons for 3 sec. TheLED should blink ORANGE continuously.On the Programmable Thermostat
  3. Hold the Thermostat -1m away from the Relay Box and press the MENU and — buttons together for 3 sec to enter the binding menu.If 14A and 0 is flashing follow steps 4-8 If 14A and 1 is flashing follow steps 9-12
  4. Press the should start flashing.
  5. Press the + button. 1 should start flashing. A small 1 will appear on the left side. If a 0 appears repeat.
  6. Press the button until SAVE is displayed. The LED on the Relay Box should change to GREEN.
  7. Press the  button to return to the Home Screen.
  8. Cycle the temperature all the way up and then all the way down to test that the Relay Box is switching on and off (this might take a few minutes).If 14A and 1 is flashing follow these steps
  9. Press the + button until 14C:0 is displayed.
  10. Press the  should start flashing.
  11. Press the + button. 1 should start flashing.
  12. Press the button to SAVE and follow steps 3-8.

Pittway Sarl, Z.A. La Pièce 4,1180 Rolle, SwitzerlandCountry of origin : UK

© 2021 Resideo Technologies, Inc. All rights reserved.The Honeywell Home trademark is used under license from Honeywell International Inc.This product is manufactured by Resideo Technologies, Inc. and its affiliates.


[xyz-ips snippet=”download-snippet”]