HCM-1CCamera Ceiling Mount – Small BaseSet-Up Guide
What’s Included:1) Qty 1 – Ceiling Mount2) Qty 1 – 1/4-20 mounting screw3) Qty 1 – 10/32 x 1/4” cup point set screw4) Qty 1 – 3/32” long arm hex wrench (for set screw)5) Qty 2 – 1/4” washers
Step 1:Screw 1” NPT pipe or pipe nipple to a properly installed mounting plate or pipe flange like that shown below. Tighten until the pipe can no longer be tightened with a pipe wrench. If using a 1.5” plate or flange, you must use a 1.5”-1” reducing bushing, like shown below.
*Notes:Plate/flange, reducer bushing, & 1” NPT pipe or nipple not included. Plate/flange must be installed according to applicable construction codes.
Step 2:Screw mount onto pipe securely, engaging a minimum of ½” of pipe into mount. When aligned to the desired location, tighten the set screw to 30-36 in-lbs of torque (this is approximately when the set screw will stop moving and the long arm – of the provided wrench – will then only bend).
Step 3:Mount camera upright to top of mount or inverted to bottJom of mount using included ¼-20 bolt through a slot in mount. Use 0-2 of the provided washers as required to make the bolt snug, so that camera is held in the desired position.
Step 4:Run cabling through pipe or dress to the outside of pipe for a clean installation aesthetic.
[xyz-ips snippet=”download-snippet”]