HuddleCamHD Small Base Camera Wall Mount Installation Guide

Table of Contents

HuddleCamHD Small Base Camera Wall Mount

What’s Included

QTY 1—Small Wall Mount BK/WHQTY 4—10-12 x 1″ Conical Plastic Anchor 1/4″ Drill Size (Fig 1, #1)QTY 4—#10-16x 1 1/4″ PPH Sheet Metal Screw with Flat Washer (Fig 1, #2)QTY 4—#6-32x 1″ PPH Machine Screw (Fig 1, #3)

Mounting Instructions

Step 1For masonry or drywall wall:Position small wall mount (Fig 2) on wall and mark wall for anchor placement (Fig 2, # 1). Pre-drill 1/4″ holes, minimum 1″ deep.For double gang electrical box:Position over the box with slots overlaying device mounting holes (Fig 2, #1) on the box.

Step 2For masonry or drywall wall:Place included anchors (Fig 1, #1) in-wall and mount to anchors using included #10 sheet metal screws. (Fig 1, #2)For double gang electrical box:Mount to box using #6 machine screws and washers. (Fig 1, #3)

Step 3Drill hole in the wall through rear exit opening for cable access, or use base exit opening. (Fig 2, #2)

Step 4Mount Camera to mount (Fig 2, #3) with included 1/4-20 machine screw. (Fig 1, # 4)Utilize (0,1,2) 1/4″ machine screw flat washers as required. (Fig 1, #4) Note: 1/4″ machine screw flat washers are to be used depending upon the depth of thread insert in the base of the camera, in order to achieve a snug fit. Pass all cables through the opening in mount (Fig 2, #2) and connect.

Mount Compatibility

HuddleCamHDHC-WEBCAM-94HC-GOHC-EPTZ-XXXHC3X-XX-G2HC3XA-XXHC3XW-XX-G2HC10X-USB2-XXHC10XA-XXHC10X-XX-G3HC20X-XX-G2

PTZOpticsPT-WEBCAM-80PTEPTZ-XXX-ZCAMPTVL-XXX-ZCAMPT12X-XXX-ZCAMPT20X-XXX-ZCAMPT12X-XXX-XX-G2PT20X-XXX-XX-G2PT30X-XXX-XX-G2

Other Cameras… This mount has been designed for use with most small-based cameras utilizing a 1/4-20″ mounting hole as can be found on SONY, Panasonic, Cisco, Polycom, and Vaddio cameras.