Mini Fridge/Freezer Thermometer
Instruction manualModel CB891
FEATURES
- Easy installation
- Large and clear digital display
- Out of safety zone alert
- Temperature unit selectable
- Low battery indication
- Low power consumption
SPECIFICATION
|
Temperature Range |
-25°C to 50°C / -13°F to 122°F |
|
Display Accuracy |
±1°C / ±1.8°F over a full range |
|
Display Resolution |
0.1° over a full range |
|
Display Reading Update |
10 seconds |
|
Safety Zone Range |
0°C to 8°C / 32°F to 46.4°F |
|
Battery |
3 volt lithium, type CR2032 or equivalent, 1 piece |
|
Product Dimensions |
42 (H) x 71 (W) x 18 (D) mm |
OPERATION
Installation
- Unpack the thermometer with care.
- Press [RESET] button once.
- Peel off display protective sheet.
- Hang the thermometer onto the shelf inside the fridge or pull down the hanger to put the thermometer on the shelf. 5. If the temperature is out of the safety zone of 0°C to 8°C (32°F to 46.4°F), then the * symbol will be flashing to indicate the temperature inside the fridge needs to be adjusted.
Select Temperature Unit
- Unscrew and open the back cover.
- Slide the °C/°F switch to the desired temperature unit.
- Put back the back cover and tighten the screws.
NOTE:
Before opening the back cover for the battery replacement or changing temperature unit, let the thermometer warm up to room temperature. The moisture may be condensed onto the electronic parts and damage the thermometer.
SYMBOLS
|
Symbol |
Description |
Action required |
|
Low battery voltage |
Replace the batteries |
|
|
LLL |
1. Sensor open circuit2. The reading is out of low range (-25°C) |
1. Return the thermometer for repair2. Keep the measurement above low range |
|
HHH |
1. Sensor short circuit2. The reading is out of high range (50°C) |
1. Return the thermometer for repair2. Keep the measurement below high range |
COMPLIANCE
Dispose of depleted batteries in accordance with local regulations, within the EC there are nominated disposal points for batteries.The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.HYGIPLAS parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities. HYGIPLAS products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior writtenpermission of HYGIPLAS. Every effort is made to ensure all details are correct at the time of going to press, however, HYGIPLASreserve the right to change specifications without notice.
[xyz-ips snippet=”download-snippet”]