HyperX Cloud Buds User Guide
Overview
- HyperX Cloud Buds
- Interchangeable ear tips
- USB-C charge cable
- Carrying case
Fitting the HyperX Cloud Buds to your ears
Changing Ear Tips
Controls
Bluetooth® Pairing
- With the headset of, hold the power button for 5 seconds to enter pairing mode. The LED indicator will flash red and blue and a voice prompt will play.
- On your Bluetooth® enabled device, search and connect to “HyperX Cloud Buds.” Once connected, the indicator LED will fash blue every 5 seconds and a voice prompt will play.
Charging
It is recommended that the headset be fully charged before first use.
| STATUS LED | CHARGE STATUS |
| Breathing Red | Charging |
| Of | Fully Charged |
Questions or Setup Issues?
Contact the HyperX support team or see the user manual at: hyperxgaming.com/support/headsets
Battery/TX Power Info
Battery Information
Contains 3.7 V, 100mAh Li-ion Battery, 0.37Wh Cannot be replaced by user
Frequency & TX Power Information
Frequency Bands: 2.4GHz(TX Power: -1dBm삯TX삯3dBm)
Regulatory Notices
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCCrules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used inaccordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment of and on, the user is encouraged to try correct the interference by one or more of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit diferent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specifed in the instruction manual.Warning: A shielded-type power cord is required in order to meetFCC emission limits and also to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment.
CAUTION: Any changes or modifcations not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
Canada Notices
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
HyperX is a division of Kingston.THIS DOCUMENT SUBJECT TO CHANGE WITHOUT NOTICE©2020 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.All rights reserved. All registered trademarks and trademarks are the property of their respective owners.
[xyz-ips snippet=”download-snippet”]