ADD LIGHT SOURCES TO YOUR STEERING DEVICE:
Before you can use your light source you’ll need to pair it with a steering device. To add more light sources, just repeat the steps below:
- Make sure that your light source is installed and the main power switch is turned on.
- Hold the steering device close to the light source you want to add (no more than 5 km away).
- Press and hold the pairing button for at least 10 seconds. A red light will shine steadily on the steering device. Your light source will begin to dim and finally flash one time to indicate that it has been successfully paired.
Up to 10 light sources can be paired with 1 steering device. Make sure to pair them one at a time. If the light sources are close to each other, disconnect those that have already been paired from the main power switch.CAUTION:DO NOT USE WITH STANDARD DIMMERS.Only use the control provided with or specified by these instructions to control this bulb.This bulb will not operate properly when connected to a standard (incandescent) dimmer or dimming control. Only controllable by IKEA Smart lighting products.With the remote control you can switch between 9 colors and white lights:White tones
Cool white | – 4000 Kelvin |
Warm white | – 2700 Kelvin |
Warm glow | – 2200 Kelvin |
Candlelight | – 1780 Kelvin |
ColorsAmber, Dark peach, Dark pink, Light purple, Light blueIf you add the gateway and the app, you get a total of 20 colors and white lights:White tones
Cold sky | – 6000 Kelvin |
Cool daylight | – 5000 Kelvin |
Cool white | – 4000 Kelvin |
Sunrise | – 3000 Kelvin |
Warm white | – 2700 Kelvin |
Warm glow | – 2200 Kelvin |
Candlelight | – 1780 Kelvin |
ColorsAmber, Peach, Dark peach, Dark red, Pink, Light Pink, Dark Pink, Light purple, Dark purple, Blue, Light Blue, Lime, YellowRESET YOUR DEVICEToggle the main switch 6 times.
TECHNICAL DATA:
Operating
frequency: | 2405 – 2480 MHz |
Output power: | 10 dBm |
Manufacturer: IKEA of Sweden AB
Address:Box 702, SE-343 81Älmhult, SWEDENThis device complies with Part 15 of the FCC Rules.This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation Science and Economic Development Canada’s license-exempt RSS standard(s).Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
WARNING:Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE INFORMATION
According to RF exposure regulations, under normal operations, the end-user shall refrain from being closer than 20 cm from the device.License rights and limitationsNO RIGHTS OR LICENSES, EXPRESS OR IMPLIED, ARE GRANTED TO USE THIRD-PARTY DEVICES IN COMBINATION WITH THESE PRODUCTS IN A WIRELESS MESH NETWORK OR TO USE THIRD-PARTY SERVICES TO ACCESS, MONITOR, OR CONTROL THESE PRODUCTS IN A WIRELESS MESH NETWORK VIA THE INTERNET OR ANOTHER EXTERNAL WIDE AREA NETWORK.For use pursuant to U.S. Patent Nos.:US 6,914,893US 7,697,492US 8,964,708The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
© Inter IKEA Systems B.V. 2021AA-2304759-1
[xyz-ips snippet=”download-snippet”]