INDIO 600032 DS-6 True Bypass Distortion Guitar Effect Pedal
SPECIFICATIONS
| Model | 600032 |
| Effect Type | Distortion with true bypass |
| Input Impedance | 1 MΩ |
| Output Impedance | 1 kΩ |
| Current Draw | 5.4mA |
| Input Power | 9 VDC battery or AC power adapter |
| Dimensions | 4.3″ x 2.4″ x 2.1″ (110 x 60 x 53 mm) |
| Weight | 7.9 oz. (225g) |
PRODUCT OVERVIEW
- DC IN: DC barrel connector for connecting an optional 9 VDC AC power adapter (not included). The internal battery is switched off when using an AC power adapter.
- LED: The LED illuminates when the effect is active. Replace the battery if the LED goes dim or does not illuminate.
- TONE: Rotate the knob to adjust the amount of frequency.
- DIST: Rotate the knob to adjust the amount of distortion.
- LEVEL: Rotate the knob to adjust the level of the output signal.
- OUT: 1/4″ TS output jack for connecting an amp or another pedal.
- IN: 1/4″ TS input jack for connecting a guitar or a previous pedal. Note that when a connector is inserted, the pedal is automatically turned on. When the pedal not in use, unplug all connections to conserve battery power.
- FOOT SWITCH: Step on the switch to turn the effect on or off. When the effect is on, the LED illuminates.
BATTERY INSTALLATION
- Remove the four screws that hold the battery compartment cover in place on the underside of the pedal, then remove the cover.
- If a battery is already installed, remove it.
- Connect the new battery, then insert it into the battery compartment.
- Position the cover over the battery compartment, then secure it in place using the four screws removed in step 1.
Monoprice™, Indio™, the Indio logo, and all Monoprice logos are trademarks of Monoprice Inc.
[xyz-ips snippet=”download-snippet”]