INSIGNIA Magnetic Charging Cable
PACKAGE CONTENTS
- Magnetic charging cable
- Cable management bumper
- Quick Setup Guide
COMPATIBILITY
Apple® Watch Series 1, 2, 3, 4, and 5
FEATURES
The silicone cable management bumper stays in place even if it is bumped.Note: Your magnetic charging cable is slightly larger than the original Apple® Charging Cable and may not fit in all charging stands designed for an Apple® Watch magnetic charging cable.
WRAPPING THE CABLE
- Wind the cord around the cable management bumper until the end with the USB connector is sticking out about an inch.Note: Make sure that you wrap it tightly.Top view
Side view - Flip the cable management bumper over and insert the USB connector into the notch in the back of the bumper.Back view
Side view
USING YOUR MAGNETIC CHARGING CABLE
- Pull out the USB connector from the back of the cable management bumper and unwind the cord.
- Plug the USB connector into your charging source (not included), then set your Apple watch on top of the charger.
SPECIFICATIONS
- Dimensions (H × D): 0.75 in. × 2.75 in. (19 mm × 70 mm)
- Cable length: 4 ft. (121.9 cm)
LEGAL NOTICES
This device complies with Part 18 of the FCC Rules. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with Part 18 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment This device complies with Industry Canada license-exempt RSS standard(s).
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
1-877-467-4289 (U.S. and Canada) www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its affiliated companies. Distributed by Best Buy Purchasing, LLC. 7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2021 Best Buy. All rights reserved.V2 ENGLISH 21-0318
[xyz-ips snippet=”download-snippet”]