iOptron Driver Installer Mount to Computer Installation Guide

IOptron Driver Installer Mount to Computer Installation Guide

Connect a CEM26/GEM28 mount to a Computer

A CEM26/GEM28 mount can be connected to a computer via USB port, or a built-in Wi-Fi. A USB2.0 cable is needed to make the connection work if connected to a computer USB port.Connect to a Windows computer is via ASCOM Platform (please refer to http://www.ascom-standards.org for detailed info.) The software/firmware needed:

  • Windows 7 /8.1 /10 with .NET (dotNET) Framework 4.8 installed;
  • Latest ASCOM Platform. Download and install it from http://www.ascom-standards.org
  • iOptron Commander and ASCOM Driver Installer 6.3 or later. Download and install it from iOptron CEM26 or GEM28 product page. CEM26/GEM28 uses Commander V6.X.
  • After installation, you should see an icon like this on your computer desktop, or your designated folder:
  • Latest mount firmware

Connect a mount to a computer via USBPlug USB B plug of a USB cable into the USB port on a 8409 hand controller as shown below. Plug the USB A plug into any available USB port of the computer.Click on Windows Device Manager to find the assigned COM port for the USB connection. Here the port # is COM4.

    • portable Devices
    • pots (COM&LPT)
      • intel(R) Active Mangement Technology – SOL(COM)
    • print queues

Click on iOptron Commander for CEM120/CEM70  open: An iOptron Commander Connection Setting window will

Select “RS-232/USB Port” with “Auto Detection”, or click on the RS-232/USB Port pull down menu to select a COM port manually. Here it is COM4 as shown below.

Click OK to connect. 

Connect a mount to a computer via Wi-Fi

The mount Wi-Fi SSID is in a form of HBX8409-XXXXXX. Turn the mount power on. Click on the Wi-Fi sign located on right bottom corner of your computer to bring up Wi-Fi network menu.Select the CEM26/GEM28 Wi-Fi network, here is HBX8409_AB4746. Click to connect to it.

Click on iOptron Commander for CEM120/CEM7 An iOptron Commander Connection Setting window will open. Select “Wi-Fi/Ethernet” and choose “CEM70G/CEM26/GEM28 Built-in/StarFi” from pull down menu. Click OK.

A Device Information window will show.Check Mount Panel to bring up the iOptron Commander 6.xx Mount Panel.Now you can control the mount via iOptron Commander, or connect your favorite planetarium software and select “iOptron CEM120/70/26/GEM28 Mount” for software configurationOther OS controlFor a MacOS, it depends on if the planetarium software has an iOptron CEM70/CEM120 driver, either embedded or plug-in. You may also use an .INDI driver developed by third party.If you are using planetary software from a SmartPhone/Tablet, such as SkySafari 6 Pro, please use the following mount and Wi-Fi settings:Error MessageIf you see this error message, please check the following:

  1.  Correct iOptron Commander is installed and used, especially you have multiple iOptron mounts;
  2. Firmware is up to date;
  3. Connection between mount and computer is established. Check Device Manager by plug and unplug the USB cable to observe the COM port changes to determine which one if from mount;
  4. Delete all COM port from other devices. Power cycle the mount and computer. Then plug in the mount first and try again.

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, , ,