User Manual
Johan Lewis Ora LED Wall light
Thank you for purchasing this Ora LED wall light. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product.
Warnings!
- For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by the law, consult a competent person who is registered with an electrical self-certification scheme. Further information is available online or phone your Local Authority.
- To prevent electric shock, switch off the mains supply before installing or maintaining this product. Ensure other persons cannot restore the electricity supply without your knowledge.
- The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
- This product is Class II =
and should be fitted to a lighting Supply protected by a 5 amp fuse or equivalent circuit breaker. - For indoor use only.
and should be fitted to a lighting Supply protected by a 5 amp fuse or equivalent circuit breaker.
Assembly
Never install your appliance on a wet, freshly painted or plastered surface.
Ensure the house electricity supply is switched off at the fuse box.
If removing an existing fitting, note down all wiring connections.
Follow the diagram for fixing detail.
Check the fixings will not touch any existing wiring before drilling and attaching the light to the wall.
Ensure you thread the wall wires through the black insulating tube fixed to the appliance.
- Ensure the house electricity supply is off at the fuse board.
- If removing an existing fitting, first note down all wiring connections.
- Remove mounting bracket from fitting by removing the retaining screws and washers, retain for later(1)
- Using the mounting bracket as a template, mark and then drill the fixing holes in the wall according to the preferred display orientation of your wall light(2) Ensure the screws are firmly fixed into a solid or other suitable mounting and not just the plasterboard.
- Attach mounting bracket to the mounting surface using suitable fixings. Do not attach fitting to mounting bracket at this stage. Make sure no wires are trapped in the process (3).
- Lever open the terminal block box cover with a screwdriver then feed supply cable through rubber sleeving and make electrical connections as follows(4):• Connect supply live (normally brown or red) to fitting live (marked “L”) on the terminal block.• Connect supply neutral (normally blue or black) to fitting neutral (marked “N”) on the terminal block.NO EARTH must be connected to any part of this fitting. If there are any earth wires present in the ceiling these must be terminated into a separate terminal block (not supplied) to ensure continuity of the earth circuit is maintained.Ensure electrical connections are tight and no loose strands of wire are left out of the connector block and the rubber sleeve is seated correctly.
- Excess cable must be carefully located inside the wall cup or within the wall cavity itself. Carefully offer fitting over mounting bracket then secure in place with the screws and washers removed earlier(5)Once installation is complete, the house electricity may be restored at the fuse box.
Care instructions
Wipe clean with a clean dry cloth, when product is switched off and has cooled down.
Specifications
Max. Power: 11WVoltage: 220-240V, 50Hz
Please retain these instructions for future reference.
John Lewis Partnership171 Victoria StreetLondon SW1E 5NNjohnlewis.comMade in ChinaIssue 1 10/17
References
[xyz-ips snippet=”download-snippet”]