Johan Lewis Tobias nickel Wall light
Thank you for purchasing this Tobias nickel wall light. Assembly Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please keep these instructions for future reference.
Warnings!
This product is Class I and must be earthed.This fitting should be fitted in accordance with IEE Regulations and the Building Regulations. If in any doubt, or where required by law, consult a competent person who is registered with an electrical self-certification scheme. Further information is available online or from your Local Authority. To prevent electric shock, switch off at the mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electricity supply without your knowledge.
If you are in any doubt, please consult a qualified electrician. If replacing an existing fitting, make a note of the connections. Always use the correct type and power bulb. Never exceed the power stated. When changing a bulb, always switch off at the mains and allow the old bulb to cool down before handling. Dispose of used bulbs carefully.Caution! The bulb and surrounding parts can become hot during use.
Care instructions
We recommend cleaning with a soft dry cloth.Do not use abrasive materials as these will damage the finish.Indoors use only.Replace bulbs from John Lewis or established brand of the same type and compatibility.
Parts list
Assembly
Ensure the mains electricity supply switched off at the fuse board.
Step 1Ensure that the bracket (supplied) is fixed to a wooden joist, or use a suitable fixing to the wall which will support the weight of the fitting.Step 2Connect cables or terminals as shown below.
Check all wires are tight in the terminal block and no loose strands are left out. Cover with insulating tape (not included)Step 3Attach wall light to fixing bracket as shown in the diagram.
Step 4Attach the correct type and wattage bulb to the lamp holder (bulb not included). The maximum power indicated must not be exceeded. Switch on the electricity supply at the fuse board.
References
[xyz-ips snippet=”download-snippet”]