Johan Lewis Zena Twist Led Floor Lamp User Manual

Johan Lewis Zena Twist Led Floor 
Lamp User Manual

Thank you for purchasing this ZENA TWIST LED FLOOR LAMP. Please read the instructions carefully before use to ensure the safe and satisfactory operation of this product.

Warnings!

  • The supply cable runs through the inside of this product. Take care not to place undue stress on the cable whilst unpacking to prevent the possibility of a poor connection.
  • If you are in any doubt consult a person competent to give advice on the assembly of electrical equipment.
  • If the external flexible cable of the lamp is damaged it shall be exclusively replaced by the manufacturer or his service agent or a similarly qualified person in order to avoid a hazard.
  • To prevent electrocution switch off at the mains supply before assembling or maintaining this fitting. Ensure the plug is not connected to any power supply and read instructions before assembly.
  • The light source of this luminaire is not replaceable; when the light source reaches the end of its end of life the whole luminaire shall be replaced.
  • If moving the floor lamp always carry it from the base. Do not lift the floor lamp by the stem only as damage may occur.

 

 

Assembly

Unpack the lamp and remove all packaging. Be careful not to scratch surfaces of the product whilst unpacking. Follow the diagram above for fixing details.

  1. Lay the product out on the floor. If the floor is not carpeted please cover it with a soft cloth to avoid damage to the flooring and surface of the product. Assembly should take place with the product laying flat.
  2. Screw the center pole onto the upper lamp holder section ensuring that the lamp holder section is kept still and that the pole is threaded on ensuring that the cable does not twist.
  3. Insert Turn the base section onto the other sections. Keep the poles parallel to avoid cross-threading. Keep the upper poles stationary and only rotate the base section.
  4. Stand the floor lamp upright and ensure all the assembled parts are fully tightened.
  5. The floor lamp is now ready for use.

Care instructions

Wipe clean with a clean dry cloth, when product is switched off and has cooled down.

Recommended bulb

1 x 21W non-replaceable LED

Specifications

Max. Power: 21WVoltage: 220-240V, 50Hz

Please retain these instructions for future reference.

John Lewis Partnership171 Victoria StreetLondon SW1E 5NNjohnlewis.comMade in ChinaIssue 1 010/17

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,