User manualSaint LEDFlush light
Warnings!This is a Class 1 product and must be earthed.Please read these instructions carefully before commencing any work to ensure safe and satisfactory operation of this product.. It is recommended that this fitting is installed by a qualified electrician. Install in accordance with the IEE Wiring regulations and the Building Regulations. To prevent electric shock switch off at mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electrical supply without your knowledge. This light fitting should be connected to a 5 amp fused circuit.If replacing an existing fitting, make a note of the connections.This product is suitable for installation on surfaces with normal flammability e.g. wood, masonry. It is not suitable for use on highly flammable surfaces (e.g. polystyrene, textiles).The LED module of this fitting is not replaceable. When the LED reaches its end of life the whole fitting should be replaced.For your safety, always switch off the supply before cleaning or adjusting.If you are in any doubt, please consult a qualified electrician.This product has special protection against the ingress of moisture and is IP44 rated. This product is suitable for use in Zone 1, Zone 2, and outside Zones of a bathroom. See diagram. If installing in a bathroom a 30mA RCD must be used in accordance with IEE Wiring Regulations and the Building Regulations.
Assembly
Refer to assembly drawing opposite. Carefully unpack the carton, making sure all the parts are present before assembly.Step 1 Before removing the existing fitting, carefully note the position of each set of wires.
Step 2Locate the ceiling plate to the ceiling, ensure there is a joist at the point of fixing to support the weight of the product, mark the position of the fixing holes. Pull the housing supply through the plate before affixing to the ceiling. Attach the ceiling plate to the ceiling using the screws supplied. Take care to avoid damaging any concealed wiring and pipes.Step 4Having identified the household wiring from your existing light fitting, connect to the connection block inside the product in the following way:
Check that…..You have correctly identified the house wires. The connections are tight. No loose strands have been left out of the connection block. The lid is fitted back onto the terminal block case.
Step 5Twist the shade clockwise to fix it in place.Step 6Replace fuse or circuit breaker and switch on. Your light is now ready for use.
Care Instructions
Care InstructionsWe recommend cleaning the electrical parts with a soft dry cloth. The acrylic shade can be washed with a damp cloth. Do not use abrasive materials as these will damage the finish.
Recommended bulb
This product contains a non-replaceable LED module. If the LEDs become damaged, then the whole unit must be replaced.Always switch off at the mains and allow the product to cool before handling.
Specifications
Maximum Power: 12WVoltage: 240V, 50HzIP Rating: IP44Weight: 0.55kg
Please keep these instructions for future reference.
This symbol
indicates that this product should not be treated as normal household waste and it should be recycled. John Lewis do not operate instore take-back but as a member of the Distributor Trade Back schemes have funded the development and upgrade of recycling facilities across the UK. Please take it to your nearest collection facility or for further details contact your local council or visit www.recycle-more.co.uk.We have taken great care to ensure that this product reaches you in perfect condition.However, should any parts be damaged or missing please contact the Product Helpline on (01202) 690945.John Lewis Partnership171 Victoria StreetLondon SW1E 5NNjohnlewis.comMade in China26/03/2020
References
[xyz-ips snippet=”download-snippet”]