John Lewis Alabaster Integrated Led Wall Light User Manual
Thank you for purchasing this Alabaster Integrated Wall Light. Please read the instructions carefully before use to ensure safe and satisfactory operations of this product. Please keep this instruction for future reference.
Warnings!
This product is Class II =
and should be fitted to a lighting Supply protected by a 5 amp fuse or equivalent circuit breaker.For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by the law, consult a competent person who is registered with an electrical self-certification scheme. Further information is available online or phone your Local Authority. To prevent electric shock, switch off the mains supply before installing or maintaining this product. Ensure other persons cannot restore the electricity supply without your knowledge. The light source of this luminaire is not replaceable; when the light source reaches the end of its end of life the whole luminaire shall be replaced. For indoor use only.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these will damage the finish.
| Part List | Qty | Part List | Qty | |
| A | 1 | B | 
|
2 |
| C | 1 |
Assembly
Never install your appliance on a wet, freshly painted or plastered surface. Ensure the house electricity supply is switched off at the fuse box. If removing an existing fitting, note down all wiring connections. Check the fixings will not touch any existing wiring before drilling and attaching the light to the wall. Ensure you thread the wall wires through the black insulating tube fixed to the appliance.
Step 1
Detach mounting bracket from fitting by removing the retaining screws and washers, retain for later. Using the mounting bracket as a template, mark and then drill the fixing holes in the wall (ensure the screws are firmly fixed into a solid or other suitable mounting and not just the plasterboard.). Take care not to damage wiring. Attach mounting bracket to the mounting surface using suitable fixings. Do not attach fitting to mounting bracket at this stage. Make sure no wires are trapped in the process.
Step 2
Ensuring that the power has been isolated, lever open the
terminal block box cover with a screwdriver then feed supply
cable through rubber sleeving and make electrical connections
as follows:
- Connect the supply Live (Normally brown or red) to
fitting live (marked “L”)
- Connect the supply neutral (blue or black) to fitting
neutral (marked “N”)
NO EARTH should be connected to any part of this fitting.
Please note that residential wiring can vary, if you are unsure about the correct polarity please consult a qualified electrician.
Step 3
Carefully offer fitting over mounting bracket and secure in place with the screws and washers removed earlier.
Once installation is complete, the house electricity may be restored at the fuse box.
Recommended bulb
7.95W LED not replaceable
Specification
Max power: 7.95W
Voltage: 220~240V, 50/60Hz IP20
Weight 1.2 Kg
Please retain these instructions for future reference.This symbol 
indicates that this product should not be treated as normal house-hold waste and it should be recycled. John Lewis does not operate in store take back, but as members of the Distributer Take Back scheme have funded the development and upgrade of recycling facilities across the UK. Please take it to your nearest collection facility or for further details contact your local council or visit www.recycle-more.co.uk.
Trouble shooting:
Why is the light not working when switched on? Check your power supply is switched on Turn off light and check that the bulb is inserted correctly Check the bulb is still in working order.John Lewis partnership171 Victoria StreetLondon SW1E 5NNJohnlewis.comMade in China
References
[xyz-ips snippet=”download-snippet”]