JOHN LEWIS Glass Cone Ceiling Pendant User Guide

Table of Contents

JOHN LEWIS Glass Cone Ceiling Pendant User Guide

Introduction

Thank you for purchasing this Glass Cone Ceiling Pendant. Please read the instructions carefully before use to ensure the safe and satisfactory operation of this product.

Warnings

This product is Class I and must be earthed.This fitting should be fitted in accordance with IEE Regulations and the Building Regulations. If in any doubt, or where required by law, consult a competent person who is registered with an electrical self-certification scheme. Further information is available online or from your Local Authority. To prevent electric shock, switch off at the mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electricity supply without your knowledge.If you are in any doubt, please consult a qualified electrician. If replacing an existing fitting, make a note of the connections. Always use the correct type and power bulb. Never exceed the power stated. When changing a bulb, always switch off at the mains and allow the old bulb to cool down before handling. Dispose of used bulbs carefully.

The flexible cable on this luminaire, if damaged, shall only be replaced by the manufacturer or his service agent, or a similarly qualified person.

It is the installer’s responsibility to ensure that the fixings and plugs used are suitable for the surface you are fixing your product on

Caution! The bulb and surrounding parts can become hot during use

Parts List

Product assembly

Ensure the mains electricity supply switched off at the fuse board.

Step 1Ensure that the bracket (supplied) is fixed to a wooden joist, or use a suitable fixing to the ceiling which will support the weight of the fitting.

Step 2 Connect cables to terminals as shown below.

Check all wires are tight in the terminal block and no loose strands are left out. Cover with insulating tape (not included).

Step 3Push up ceiling cup and secure with grub screws provided.

To adjust the height of the fitting, loosen the plastic grub screw on the ceiling plate, and then adjust the cable to the required length and then re-tighten the grub screw

Step 4Attach shade onto the lamp holder and then secure with shade ring.

Step 5Attach the correct type and wattage bulb to the lamp holder (bulb not included). The maximum power indicated must not be exceeded.Switch on the electricity supply at the fuse board.

Caring for your product

Indoor use only Dimmable Replace bulbs from John Lewis or established brand of the same type and compatibility Recommended the fitting should be cleaned with a soft dry cloth.

Aftercare and Troubleshooting

Why is the light not working when switched on?Check your power supply is switched on Turn off the light and check that the bulb is inserted correctly Check the bulb is still in working order.If you experience any unresolvable technical issues with the product, contact your nearest John Lewis & Partners shop or John Lewis & Partners Technical Support on 03301 230106.

Specification

Recommended bulb: ES GLS bulbRated power: 40W MaxBulb not includedVoltage: 220 240V, 50HzIP rating: 20Weight: 0.95kg

5-year guarantee

At John Lewis & Partners we test every light to high-quality standards so we are able to offer you a 5-year guarantee.

Recycling

This symbol indicates that this product should not be treated as household waste and should be recycled. John Lewis & Partners do not operate instore take back, but as members of the Distributor Take Backscheme have funded the development and upgrade of recycling facilitiesacross the UK. Please take it to your nearest collection facility or for furtherdetails contact your local council or visit www.recycle-more.co.uk.