Thermo-Kitty PlayhouseAssembly Instructions
Thank you for purchasing a Thermo-Kitty Playhouse from K&H Pet Products. When used correctly, the Thermo-Kitty Playhouse should provide your kitty with hours of interactive playtime and sleeping.(Additional cardboard refi ll scratching pads can be purchased separately to keep your kitty’s Playhouse in tip-top condition)WARNING: This is an electrical product. Read all directions and precautions carefully before operating. Failure to properly follow all directions and instructions may lead to electrical shock of fi re which could cause serious bodily injury.
USE INSTRUCTIONS
Read all instructions carefully. This is an electrical product, pay special care to IMPORTANT SAFEGUARDSThermo-Kitty Playhouse ASSEMBLY INSTRUCTIONS:
- To assemble the Thermo-Kitty Playhouse, unfold the main house structure. Locate the pet bed heater and the plush pad. Unzip the pad and insert the heater with the cord exiting out the corner. See Figure 1. Close the zipper.
- Place the plush pad into the house structure making sure the heater’s cord goes in the back corner where the cord exit hole is. See Figure 2. Feed the cord through the hole in the crease and out the backside of the Playhouse.
- Install the cardboard scratching pad into the top section of the Playhouse. See Figure 3. Done! Your cat will be thrilled to have a new place to play, scratch, and sleep! to lay, scratch, and sleep!
CARE INSTRUCTIONS:Wipe house structure ipe house structure clean with a damp cloth. Remove heater before machine washing plush pad.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed including the following:
- Read all instructions.
- To protect against electrical hazards, DO NOT immerse cord, plug or appliance in water or other liquid.
- Close supervision is necessary when used by or near children.
- ALWAYS unplug from the outlet when not in use.
- DO NOT operate any electrical appliance with a damaged cord or plug, or if the appliance malfunctions or has been damaged in any manner. RETURN all malfunctioning appliances to the manufacturer for examination.
- DO NOT use an appliance for anything other than its intended use.
- DO NOT PUNCTURE THE HEATER FOR ANY REASON.
- For use with 110-120 volt AC ONLY.
- ORD MUST EXIT towards the back of bed, away from normal travel of pet.
- A liner must separate the pet bed warmer from the stuffing material.
- When using this product, make sure your pet has the option of sleeping on or OFF the bed.
SAVE THESE INSTRUCTIONS FOR YOUR USE. Testing your Pet Bed HeaterAfter operating for 1-2 hours, place your hands on your pet’s bed for 20-30 seconds applying light pressure. You will feel the radiant warmth that your pet will enjoy.
K&H Limited One Year WarrantyOur warranty is as follows: K&H Pet Products warrants to the original consumer, that this product will be free of defects and workmanship for a period of one year from the date of purchase. The manufacturer’s liability hereunder is limited to the replacement of the product. This warranty is void if the product has been damaged by accident, unreasonable use, neglect, tampering, or other causes not arising from defects in material and workmanship. To exercise your warranty: If, during the warranty period, your product malfunctions, return it to the place of purchase with your original purchase receipt. If this cannot be done, return the product, postage prepaid, to K&H Pet Products, with a dated proof of purchase or original date receipt. A return authorization number can be obtained by calling ( 719 ) 591-6950 and must accompany all returns to the manufacturer. Please include a note explaining the problem when returning the product.
K&H Pet Products with design is a registered trademark of Central Garden & Pet Company.©2020 Central Garden & Pet Company
Made in ChinaK&H Pet Products, Central Garden & PetColorado Springs, COwww.khpet.com l (719) 591-6950
References
[xyz-ips snippet=”download-snippet”]