KLEIN TOOLS 56413 Rechargeable 2-Color LED Flashlight with Holster Instruction Manual

Rechargeable 2-Color LED Flashlight with Holster Instructions56413

CONTENTS

  • 56413 Rechargeable 2-Color LED Flashlight
  • 6″ USB-C Cable
  • Holster
  • Instruction Manual

GENERAL SPECIFICATIONS

  • Battery Cell Type: 18650
  • Cell Chemistry: Lithium-Ion
  • Operating/Storage Altitude: 6562 ft. (2000 m)
  • Operating/Charging Temperature: 32° to 104°F (0° to 40°C)
  • Storage Temperature: -22° to 140°F (-30° to 60°C) (up to 3 months)
  • Storage Humidity: <75% Relative humidity
  • Relative Humidity: <85% non-condensing
  • Charging Time: Charge from empty to full in 6 hours
  • Shelf Life: Charge every 3 months
  • Life Expectancy: Up to 500 charging cycles typical (depending on use & care)
  • Battery Capacity: 2600mAh
  • Charging Requirements: 5V 0.650A, 3.25W
  • Drop Protection: 6 ft. (2 m)
  • Ingress Protection Rating: IP64
  • Standards: REACH, RoHS, CE-EMC, CEC, NRCAN

Specifications are subject to change.

WARNINGSRead, understand, and follow these instructions to ensure safe operation. Failure to observe these warnings can result in a risk of fire, electric shock, serious injury, and/orproperty damage.

  • Use of a power supply, charger, or cable not recommended or sold with this unit may result in a risk of fire or injury to persons.
  • DO NOT use the product if it is damaged or modified.Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion, or injury.
  • DO NOT subject to vibration, impacts, or drops. The housing may not show signs of damage, but internal components may have been compromised. It is advisable to replace the unit if any such severe events occur.
  • DO NOT expose to direct sunlight, open flame, heat sources, equipment that produces heat, or extremes in environmental temperature.
  • DO NOT expose the product to rain or snow.
  • Keep away from high voltage devices.
  • DO NOT attempt to repair the flashlight or charging cable.There are no user-serviceable parts.
  • DO NOT immerse in water or other liquids. Avoid spilling liquids or falling foreign objects into openings on the unit.
  • Risk of fire and burns. DO NOT open, crush, heat above the manufacturer’s specified maximum temperature, or incinerate.
  • Properly seal the charging port cover to achieve specified water & foreign object ingress protection. Keep seal free of dirt, oil, sand, or other material that interferes with proper sealing. Failure to do so can result in a risk of fire or electric shock.
  • DO NOT open the charging port cover if wet or in a wet environment. Thoroughly dry the unit and the seal around the water-resistant cover completely before opening the water-resistant cover.
  • When the flashlight is in use or charging, make sure there is adequate space to allow ventilation of internally generated heat.
  • Use a safety-rated power supply or wall adapter. Never use a power supply or wall adapter that exceeds the specified charging voltage and current.
  • Route the power supply cable so that it will not be stepped on or pinched by other objects.
  • Follow Manufacturer’s Instructions.
  • DO NOT attempt to insert other USB connector types into the USB-C port.

FEATURE DETAILS (FIG. A)

  1. LED light
  2. Battery level indicator
  3. USB-C charging port
  4. Pocket clip
  5. Power button
  6. Magnet
  7. USB-C charging cable

WARRANTY

www.kleintools.com/warranty

DISPOSAL / RECYCLE

Do not place equipment and its accessories in the trash. Items must be properly disposed of in accordance with local regulations. Please see www.epa.gov orwww.erecycle.org for additional information.

OPERATING INSTRUCTIONS

PLEASE SEE THE REVERSE SIDE.

CUSTOMER SERVICE

KLEIN TOOLS, INC.450 Bond Street, Lincolnshire, IL 60069 1-800-553-4676[email protected]www.kleintools.com

SYMBOLS ON PRODUCT

Warning or CautionRisk of Electrical ShockConformité Européenne. Conforms with European Economic Area directivesWEEE – Battery disposalConforms with BCS regulations of the California Energy CommissionDirect Current (DC)Read Instructions

Recycle

MAINTENANCE

  • CLEANING: Disconnect the device from all power sources and devices prior to cleaning. Use a clean, dry, soft, lint-free cloth to wipe down the entire unit. DO NOT use abrasive cleaners or solvents.
  • STORAGE: If storing for more than 1 month, charge completely before storage, and recharge approximately every 3 months to avoid full discharge. Store in cool temperatures, mild humidity, and away from direct sunlight (See GENERAL SPECIFICATIONS). Leaving the unit in a vehicle or other confined spaces in extremely hot temperatures can lead to a decrease in service life, overheating, or fire. Extreme cold temperatures below the specified storage range can also harm performance and service life. Keep away from corrosive chemicals and gases. After taking out of storage, inspect visually to make sure the device and all accessories look satisfactory. Allow unit to return to ambient conditions before recharging or charging other devices.
  • RECHARGING: Recharge as needed. There are no predesignated intervals at which to recharge as long as you are using the unit regularly. Avoid discharging completelyon a regular basis, as this can impact overall life. Regularly inspect ports and charging cables for any debris, dirt, damage, and corrosion. DO NOT attempt to fix. Replace device and/or cable as needed.

OPERATING INSTRUCTIONS

Read these instructions carefully before operating and keep them for future reference.CHARGING BATTERYTo access the charging port, twist the collar just below the flashlight head. After charging, please return the collar to the original position to protect the charging port.Connect USB-C cable connection to the flashlight; plug the other end of the cable into USB (2.0 or higher) port, or AC adapter (not included). USB adapter/power supply should not exceed the specified charging voltage and current (Max.5.0V DC, min. 0.650A).

  • The battery level indicator will illuminate:• Solid Green: 100% charge• Blinking Green: 50-99% charge• Blinking Yellow: 26-49% charge• Blinking Red: 16% to 25% charge• Solid Red: 0% to 15% charge

A full charge could take up to 6 hours, depending on the charger’s output. Charge completely before using. To maximize battery life, see the MAINTENANCE section (otherside).NOTE: When charging the flashlight, the unit will not operate in all modes.DISCHARGING BATTERY

  • The battery indicator shows for 5 seconds when powered on.

POWER ON/OFF BUTTON

  • To activate the flashlight, press and release the power button 5. The unit will be in HIGH flashlight mode.
  • Hold down the power button to change between modes.Once the desired mode is on, clicking the power button will reduce the brightness. This flashlight has a white LED spotlight, white LED area light, and red LEDs.
  • NOTE: If the light is on for more than 5 seconds in ANY mode, the next press of the power button will shut it off. This saves the time clicking through modes to powerdown.
  • NOTE: The light will turn on in the same mode last used when turned off.

MOUNTING OPTIONS

  • The magnet 6 on the endcap can be mounted onto any ferrous surface.
  • Pocket clip 4 can be removed by unscrewing the endcap.
  • The holster can be attached to a belt, and the flashlight stored inside.
report this ad

TROUBLESHOOTING

  • 56413 will NOT recharge IF: The cable is not properly connected to charger output or battery input. Check connection.• The charging cable is damaged. Replace with equivalent cable.• The charging port or device is not able to supply the minimum voltage and current for charging. Connect to an appropriate charging source.

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,