KOHLER Heated Bubble Massage air bath with Bask
Features
- Bask® heated surface creates spa-like relaxation with soothing warmth on your back, shoulders and neck.
- Three heat settings allow you to customize the surface temperature.
- 118 to 122 airjets release thousands of heated bubbles that surround and support the body in a warm massage.
- Purge cycles remove residual water from air channels after use to keep the system clean.
- Variable-speed blower lets you adjust massage intensity to 18 levels.
- 16″ depth offers a deep soaking experience.
- Integral lumbar support on both ends.
- Bottom surface manufactured with textured appearance.
- Wide ledge on one side is ideal for deck-mount faucet and/or hand shower.
- Center drain.
- Straight shroud.
Material: Acrylic.
Technology
- Bath includes auto purge (after bath drains) and manual purge cycles to remove residual water and keep system clean.
- Auto-shutoff timer on blower allows users to enjoy Heated Bubble Massage™ experience for 60 minutes before turning off.
- Built-in 60W electric heater included to keep bath surface warm.
- User interface: two separate electronic keypad controls for Heated Bubble Massage™ and Bask®.
Installation
- Freestanding design creates a striking focal point in your bathing area.
- PureFlo™ drains are not recommended for a deck-mount faucet installation.
- Remote blower motor installation required (relocation kit is included).
Recommended Products/Accessories
K-7265 Clearflo Bath DrainK-24916 Wireless Music KitK-37383 30″ Rough-in Cable Bath DrainK-37386 rough-in cable drain, PVC, 30″ cable
Codes/Standards
ASME A112.19.7/CSA B45.10CSA B45.5/IAPMO Z124ASTM E162ASTM E662UL 1795CSA C22.2 No. 218.2Greenguard UL 2818 – Gold
Five-Year Limited Warranty: See website for detailed warranty information.
Overview
Required Electrical ServiceTwo dedicated circuits required, protected with Class A Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD).
Technical Information
All product dimensions are nominal.
Installation: FreestandingBasin area, bottom: 40-5/16″ x 22-1/2″ (1024 mm x 572 mm)Basin area, top: 49-3/8″ x 22-7/8″ (1254 mm x 581 mm)Weight: 160 lbs (72.6 kg)Minimum floor load: 54 lbs/ft² (263.7 kg/m²)Water depth: 18″ (457 mm)Water capacity: 60 gal (227.1 L)Template: Footprint, 1364289, not required, not includedElectrical component rating:
Blower: 120 V, 10 A, 60 HzHeated Surface: 120 V, 0.5 A, 60 HzHeater: 120 V, 5 A, 60 Hz
Notes:
- Measure your actual product for rough-in details.
- Install this product according to the installation instructions.
- The hot water supply should be 70% of the capacity of the bath or greater. Installations will vary.
- Provide one grounded electrical outlet within 24″ (610 mm) of each component.
- This bath is designed for freestanding installation only.
- If installing a rim-mount faucet, make sure there is no interference above or below the deck before drilling any holes.
1-800-4KOHLER (1-800-456-4537)Kohler Co. reserves the right to make revisions without notice to product specifications. For the most current Specification Sheet, go to www.kohler.com4-25-2019 20:08 – US
References
[xyz-ips snippet=”download-snippet”]