Dots2 Touch
User Guide
Controls
| Switch on | Hold down the multifunction button for 3 seconds |
| Play / Pause | Press multifunction button |
| Next track | Press multifunction button twice |
| Previous track | Press the multifunction button three times |
| Accept / End call | Press multifunction button |
| Reject Call | Hold down the multifunction button for 1 second |
| Redial last number | Press the multifunction button four times |
| Activate mobile assistant | Hold down the multifunction button for 2 seconds |
Switching on
The headphones turn on automatically when removed from the charging station. To switch on manually, hold down the multifunction button for 3 seconds. You must manually turn on both headphones separately. An alert is heard when the device is switched on and the blue LED flashes three times.
Switching off
The headphones switch off automatically when docked in the charging station.
Pairing
- Remove the headphones from the charging station. The headphones will connect to each other automatically and an alert will sound. The right headphone will act as the “main” headphone and will be ready for pairing. This is indicated by the alternating flashing of the blue and red LEDs.
- Turn on Bluetooth on your device and search for LAMAX Dots2 Touch in the list of available Bluetooth devices. An audio alert will sound once the device and headphones have been successfully paired.
If you encounter any problems while attempting to pair the headphones with a device, remove the headphones from the list of paired devices on your phone. Remove the headphones from the charging station. The headphones will turn on automatically and start flashing blue and red alternately. Then manually hold the multifunction button on both headphones for 9 seconds until the headphones flash blue 5 times. Then, when the headphones start flashing red and blue alternately again, insert them into the chargingstation and pair according to point 1.
Charging
To recharge the charging station, connect the cable to the USB-C port on the back of the charging station and connect the other end of the cable to a USB power supply with a maximum voltage of 5V. When charging, the LEDs will light up gradually according to the state of charge. When fully charged, all 4 diodes will light up.To charge the headphones, dock them into the charged charging station. The LEDs on the headphones will light up red when charging. When fully charged, they will light up blue for 10 seconds, then deactivate.
Parameters
| Wireless technology | Bluetooth 5.0 |
| Maximum pairing distance | up to 10 meters |
| Supporting codecs | AAC, SBC |
| Headphone battery capacity | 50 mAh |
| Charging station capacity | 550 mAh |
| Headphone charging time | approx. 2 hours |
| Playback time | up to 6 hours |
| Weight of each headphone | 3,7 g |
| Weight including charging station | 40 g |
Printing errors reserved.The current version of the user manual can be downloaded here:https://www.lamax-electronics.com/downloads/lamax-dots2touch/manual
https://www.lamax-electronics.com/downloads/lamax-dots2-touch/manual
References
[xyz-ips snippet=”download-snippet”]