Leap Frog 80-612100 Colorful-Counting-Red-Panda User Guide

Colorful Counting Red Panda™Parent’s GuideThis guide contains important information. Please keep it for future reference. 91-003941-003


Thank you for purchasing the Colorful Counting Red Panda™! Learning colors, counting and cuddling have never been so adorable and fun!Heart Button Music Button Off/Low/High Volume Selector


  • Colorful Counting Red Panda™
  • Parent’s guide

WARNINGAll packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords, and packaging screws are not part of this toy and should be discarded for your child’s safety.NOTEPlease keep this parent’s guide as it contains important information.



  1. Make sure the unit is turned Off.
  2. Find the battery cover located on the back of the unit, use a screwdriver to loosen the screw, and then open the battery cover.
  3. Remove old batteries by pulling up one end of each battery.
  4. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
  5. Replace the battery cover and tighten the screw to secure.

WARNING / ATTENTION :Adult assembly is required for battery installation.Keep batteries out of reach of children.


  • Insert batteries with the correct polarity (+ and -).
  • Do not mix old and new batteries.
  • Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
  • Only batteries of the same or equivalent type as recommended are to be used.
  • Do not short-circuit the supply terminals.
  • Remove batteries during long periods of non-use.
  • Remove exhausted batteries from the toy.
  • Dispose of batteries safely. Do not dispose of batteries in a fire.


  • Remove rechargeable batteries from the toy before charging.
  • Rechargeable batteries are only to be charged under adult supervision.
  • Do not charge non-rechargeable batteries.

NOTEThis product is in Try-Me mode in the packaging. After opening the package, turn the Colorful Counting Red Panda™ off and on again to proceed with normal play. If the unit repeatedly powers down while playing, please install a new set of batteries.


  1. Off/Low/High Volume SelectorSlide the Off/Low/High Volume Selector to turn the toy on and select the Low or High volume.
  2. Heart ButtonPress to hear counting, colors, cute sayings, and silly phrases.
  3. Music ButtonPress to hear counting, color songs, and three dance tunes.
  4. Automatic Shut-OffTo preserve battery life, the Colorful Counting Red Panda™ will automatically shut off after approximately 30 seconds without input. The unit can be turned on again by pressing any button.


Color CheerRed, yellow, green, blueI love colors how about you?Color SongRed, yellow, orange and blue – Green and purple, too!I’m Gonna Count on You to Cuddle MeI’m gonna count on you to cuddle me!Give me a hug (or two or three!)One!Two!Three!Four!Huggle me, snuggle me, cuddle me more!Counting to 10I love you! Cuddle me and let’s count to 10.1, 2, 3, 4, 5, 6, 7, 8, 9, 10.Aw! You are my bestest friend ever!

If You’re Silly and You Know ItVerse 1:If you are silly and you know it claps your paws!If you are silly and you know it claps your paws!If you’re silly and you know it and you really want to show it,If you are silly and you know it claps your paws!Verse 2:If you are silly and you know it panda dance!If you are silly and you know it panda dance!If you’re silly and you know it and you really want to show it,If you are silly and you know it panda dance!


  1. Keep the unit clean by wiping it with a slightly damp cloth.
  2. Keep the unit out of direct sunlight and away from direct heat sources.
  3.  Remove the batteries if the unit will not be in use for an extended period of time.
  4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.


If for some reason the unit stops working or malfunctions, please follow these steps:

  1. Turn the unit Off.
  2. Interrupt the power supply by removing the batteries.
  3. Let the unit stand for a few minutes, then replace the batteries.
  4. Turn the unit back On. The unit should now be ready to use again.
  5. If the unit still does not work, install a new set of batteries.

Environmental PhenomenaThe unit may malfunction if subjected to radio-frequency interference. It should revert to normal operation when the interference stops. If not, it may become necessary to turn the power Off and back On or remove and reinstall the batteries.In the unlikely event of an electrostatic discharge, the unit may malfunction and lose memory, requiring the user to reset the device by removing and reinstalling the batteries.

IMPORTANT NOTE:If the problem persists, please call our Consumer Services Department at 1-800-701-5327 in the U.S. or email [email protected]. Creating and developing LeapFrog® products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products.However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

CAUTIONChanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTEThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Supplier’s Declaration of Conformity 47 CFR § 2.1077 Compliance Information

report this ad

Trade Name: LeapFrog®Model: 6121Product Name: Colorful Counting Red Panda™Responsible Party: LeapFrog Enterprises, Inc.Address:2200 Powell Street, Suite 500 Emeryville, CA 94608.Emery Website: leapfrog.com

Visit our website for more information about our products,downloads, resources, and more.leapfrog.comRead our complete warranty policy onlineat leapfrog.com/warrantyLeapFrog Enterprises, Inc.,A subsidiary of VTech Holdings Limited.TM & © 2021 LeapFrog Enterprises, Inc.All rights reserved.Printed in China.91-003941-003


[xyz-ips snippet=”download-snippet”]