IQxelTM
Next Generation Connectivity Test System
General Technical Specifications
RF Analyzer
RF Analyzer — Signal Trigger
Baseband Analyzer
RF Generator
1 Automatic Level Control (ALC) enables the internal power detector to be used for power level feedback.
Baseband Generator
Port Isolation
Timebase
Wireless LAN (802.11a/b/g/n/p/ac) Measurement Specifications
Bluetooth® (1.0, 2.0, 2.1, 3.0) Measurement Specifications
1 IQxel supports testing sensitivity with Dirty Packets
Bluetooth (4.0, 4.1, 4.2) Measurement Specifications
1 NOC and EOC tests are the same except for the operating conditions which do not impact the test equipment requirements
2 External signal source required for these measurements (not LitePoint supplied)
3 IQxel provides the wanted signal only. No interfering signal is available
Bluetooth 5 Measurement Specifications
Bluetooth 5 introduced a couple of new test requirements:
Data Rate: New requirements for testing with 2 Mbps, 1 Mbps, 500 kbps, 125 kbps signal
Stable Modulation: Optional requirement for device to support smaller variation in the frequency deviation during modulation (modulation index between 0.495-0.505). This enhancement gives device stable and better range coverage and thus competitive advantage
ZigBee (802.15.4)
Z-Wave (ITU-T G.9959)
WiSUN MR-FSK (802.15.4g)
DECT (ETSI EN 300 176-1)
MIMO System Performance
The additional specifications in the table below apply to the complete IQxel MIMO system
Port Descriptions
Front Panel
Rear Panel
General I/O
Communication I/O
General and Environmental
Order Codes
IQxel Next Generation Connectivity Test System Specifications Manual – IQxel Next Generation Connectivity Test System Specifications Manual –
[xyz-ips snippet=”download-snippet”]