FLIGHT CONTROLLER F405-SEQUICK START GUIDE
MCU: 168MHz STM32F405RGT6IMU: MPU6000Baro: DPS310OSD: AT7456EBlackbox: MicroSD slot6× Uarts1× Softserial supported9× PWM outputs2× I2C3× ADC (voltage, current, RSSI)4× RX6 pad(one per corner) for BLheli32 ESC telemetry4× individual ESC power/signal pads1× Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
Vbat filtered output power for VTXPWM Camera controlSmartaudio & Tramp VTX protocolDJI FPV OSD protocolInput: 6~36V (3~8S LiPo)PDB: 4x35A (Max.4x46A)BEC: 5V 2A cont. (Max.3A)LDO 3.3V: Max.200mACurrent Sensor range 184ABattery Voltage Sensor: 1K:10KINAV Target: MATEKF405SEBetaFlight Target: MATEKF405SEArduPilot hwdef: MATEKF405-WING
LAYOUT
Cam: Camera video INVTX: Video OUT to Video TransmitterVbat: Battery voltage filtered, Max.1A load on this pad.G: Ground*** S9 has 200ohm integrated in series, can be remapped as PWM camera control (CLI resource camera_control A08)
Rx3 & Tx3: UART3Rx4 & Tx4: UART4
Rx5 & Tx5: UART5CL2 & DA2: I2C2_SCL & SDARx2: UART2_RX, PPM share RX2 padTx2: UART2_TXSbus: Uart2_RX with inversion for SBUS receiver protocol*** TX2 can be remapped as softserial_tx1 for Frsky SmartPort in BetaFlight(CLI resource SERIAL_TX 11 A02)*** Softserial1_TX is enabled on Tx2 pad by default in INAV
Wiring (Individual ESC)
Wiring (4in1 ESC)
References
[xyz-ips snippet=”download-snippet”]